Remote Control Programming - Leggett & Platt style series Owner's Manual

REMOTE CONTROL PROGRAMMING (1 remote control - 1 base)
Program One Remote to Operate One Base - perform the
following numbered procedure.
STEP 1
Remove the battery compartment door from the
remote control (FIGURE 9).
FIGURE 9
BATTERY
LEARN
COMPARTMENT
SWITCH
DOOR
STEP 2
Make sure adjustable base is plugged into
electrical power source. Position base on its
side. Locate the power down device (FIGURE
10).
STEP 3
Push the power down reset button in two
times in rapid succession (FIGURE 10). The
underbed lighting will come on.
FIGURE 10
RESET
BUTTON
STEP 4
On the remote control, press and hold the learn
switch (FIGURE 9)
until the underbed lighting
.
goes off
STEP 5
Operate remote control to verify programming.
One remote control is now programmed to
operate one base.
STYLE™
MOTOR
attached to
underside
of adjustable base
RESET LIGHT
POWER DOWN
DEVICE
factory pre-wired
to motor
99301567-d
foundation design
15