Specifications - BRADLEY MOWERS 48SC Owner's Manual & Parts List

ENGINE OIL
Do not perform engine maintenance without the
engine off, spark plug wires disconnected and
PTO disengaged.
AFTER FIRST FIVE
While the engine is warm:
1. Release the oil drain hose assembly from the engine
clip J. Lay hose assembly over the frame edge.
2. Remove the screwed plug D from the tip of the hose
assembly to allow oiI to drain from the engine.
Dispose of used oil in accordance with local
requirements.
3. Clean plug connector and screwed plug D. Replace
screwed plug back into plug connector. Replace
hose assembly back into engine clip.
4. Change oil filter.
5. Fill the crankcase with fresh oil to the full mark. Do
not overfill. See engine manual for oil specifications.
DAILY
1. Check oil level with the dipstick.
2. If oil is needed, add fresh oil of proper viscosity
and grade. See engine manual for oil specifications.
Do not overfill.
3. Replace dipstick before starting engine.
PERIODIC OIL CHANGES
1. See engine manual for oil and filter change intervals
after the break-in period .
2.
Follow instructions for first oil change, above.
SPARK PLUGS
Remove each plug and check condition.
Good operating conditions are indicated if the plug has a light coating of grey or tan deposit.

A white blistered coating indicates overheating. A black coating indicates an "over rich" fuel mixture.

Both may be caused by a clogged air cleaner or improper carburetor adjustment.
Do not sandblast, wire brush or otherwise attempt to repair a plug in poor condition. Best results are

obtained with a new plug.
Set plug gap as specified in engine manual.

FUEL FILTER
An in line fuel filter is located in the fuel supply line. Inspect at every oil change to make sure it is clean and
unobstructed. Replace if dirty.
Bradley Stand-On Compact Mower Owner's Manual
(5) HOURS
13