Installing The Solid-State Drive; Hard Drive; Removing The Hard Drive - Dell Precision 5520 Owner's Manual

Installing the solid-state drive

1 Adhere the thermal pad to the solid-state drive.
NOTE: The thermal pad is applicable only for a PCIe SSD card.
2 Slide the solid-state drive at an angle into the solid-state drive slot.
3 Press the other end of the solid-state drive down and replace the M2 x 3 screw that secures the solid-state drive to the system
board.
4 Install the:
a battery
b base cover
5 Follow the procedures in After Working Inside Your Computer.

Hard drive

Removing the Hard Drive

1 Follow the procedures in
2 Remove the:
a Base cover
b battery
3 Perform the following steps to remove the hard-drive bracket from the computer:
a Remove the four M2x4 screws securing the hard-drive bracket to the computer [1].
b Lift the hard-drive cage [2] off the hard drive assembly [3].
10 Removing and installing components
Before Working Inside Your Computer.