Error Codes - Renfert Silent TS2 Instruction Manual

Error
Extractor starts,
although a connected
device is not being
used.
Extractor fails to stop
when a connected
device is switched off
No satisfactory setting
for the automatic
start-up feature can be
adjusted.
to open.
The extraction force is
not readjusted when a
second suction hose is
switched on or off
The display indicates
"OFF" above the button
(41)
There is no audible
signal.
Pinch valves close /
open slowly
7.1

Error codes

Switch device off
Deal with the fault as described in the table
Switch the device back on
For all other error codes, switch the unit off and then back on again.
Make a note of the error code.
Contact the repair service
Error Code
Cod01
reached.
Err01
Err04 Overheated electronics
Possible Cause
Start-up threshold of one suction
hoses is too low.
The dust generating device is not
plugged in to the coupler socket on
the extractor and the suction hose
button is switched on.
Start-up threshold is too low
Shut-off delay is too long.
Some older hand pieces do not
for the automatic start-up feature.
Lock bolts are dirty.
The automatic extraction force
readjustment is deactivated.
The automatic extraction force
readjustment is deactivated.
The audible signal is deactivated.
connection is blocked
Cause / Meaning
Corrective Action
Check, which suction hose is open, the relevant letter
will be indicated in the display.
Adjust the start-up threshold of the suction hose
(Chapter 5.3.4).
Switch the suction hose button on the extractor off,
and connect the dust generating device to the coupler
socket on the extractor (Chapter 4.7).
Adjust start-up threshold (Chapter 5.3.4)
Set shorter shut-off delay (Chapter 5.3.5).
Switch to higher revs per minute (e.g. 10,000 rpm.)
Clean lock bolts and lubricate them slightly if
necessary.
Activate the automatic extraction force readjustment
(See chapter 5.2.2).
Activate the automatic extraction force readjustment if
required (See chapter 5.2.2).
Activate audible signal (Chapter 5.3.2)
(see chapter 6.2.4).
Corrective Action
Change dust bag (Chapter 6.1).
Check the suction hoses for blockages, examine
contamination, and change if necessary (see chapter
6.2.1).
If the device is supplied with compressed air from
a main laboratory switch together with the air
Switch the extractor off and allow cooling. If the
extractor is located in a closed cabinet, make sure
the exhausted air is able to escape (See chapter 4.2).
- 17 -
EN