[1] The PoE source (network switch) must be located in the same building as the Cisco TelePresence Touch 10. Otherwise the Cisco Aironet Power Injector must be used. The Ethernet cable (Cat5) can be up to 100 m (330 ft).
Remote pairing Connect Touch 10 Connect the Touch 10 to a network socket. Option A: When the network socket does not provide Power over Ethernet (PoE) you will need a mid-span PoE injector to power Touch 10. Option B: The network socket provides Power over Ethernet (PoE). Touch 10 set-up Once Touch 10 is connected to power, the set-up procedure begins.
Page 4
Direct pairing Connect Touch 10 Connect the Touch 10 to the network socket on the codec or endpoint. Option C: Note that the SX Series do not provide Power over Ethernet (PoE), so you need a mid-span PoE injector to power Touch 10. Option D: The MX Series (MX200G2, MX300G2, MX700, MX800) provides Power over Ethernet (PoE).
Page 5
Additional product support User documentation For more information about Cisco TelePresence Touch 10, see the user documentation that is available on our web site: http://www.cisco.com/go/touch-docs If asked to sign in or to configure your system, you may want to consult the user documentation for the TelePresence endpoint.
Page 6
170 West Tasman Dr. San Jose, CA 95134 USA Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks.
Need help?
Do you have a question about the TelePresence Touch 10 and is the answer not in the manual?
Questions and answers