Do you have a question about the 9 SERIES and is the answer not in the manual?
Questions and answers
Barbara Selinger
February 25, 2025
if we have a broken one, is there a way to send it to you to fix it
1 comments:
Mr. Anderson
February 25, 2025
Yes, Braun 9 Series shavers can be sent in for repair if they exhibit defects in material or workmanship within the two-year limited warranty period, excluding the foil and cutter block. The shaver must be shipped in its original packaging with the original sales receipt. Users should call 1-800-BRAUN-11 (1-800-272-8611) to be referred to the nearest authorized Braun Service Center.
This answer is automatically generated
Barbara Selinger
February 25, 2025
where is the model number listed
1 comments:
Mr. Anderson
February 25, 2025
The model number for the Braun 9 Series is located on the device and is part of the series identifiers such as 9297cc, 9296cc, 9295cc, 9292cc, 9291cc, 9290cc, and 9280cc. It is also mentioned in the manual as "Type 5791."
Page 26
English Our products are designed to meet the highest standards of quality, functionality and design. Thank you for your trust in Braun’s quality, and we hope you enjoy your new Braun shaver. Read these instructions completely, they contain safety information.
Page 27
The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator. Do not refill the cartridge and use only original Braun refill cartridges. Shaver Foil &...
Page 28
• During charging the respective battery segment will blink. • When fully charged all battery segments will light up for a few seconds then the display turns off. Low charge The low-charge light flashes red when the battery is running low. You should be able to finish your shave.
Page 29
Clean&Charge Station (not with all models) The Clean&Charge Station has been developed for cleaning, charging, lubricating, disinfecting, drying and storing your Braun shaver. 12 Station power socket Lift button for cartridge exchange Station-to-shaver contacts 15 Clean&Charge Station display...
Page 30
• Slowly close the housing by pushing it down until it locks. • Connect the station to an electrical outlet by snapping the special cord set (10) into the power socket (12). Charging the shaver in the Clean&Charge Station (see fig. D) Insert the shaver head with the front showing and released head lock into the cleaning station.
Page 31
Clean&Charge Station. These marks can be removed easily by wiping gently with a damp cloth. Accessories Braun recommends changing your shaver’s Foil & Cutter cassette every 18 months to maintain your shaver‘s maximum performance. Available at your dealer or Braun Service Centres: •...
Page 32
Trouble-Shooting Problem: Possible reason: Remedy: SHAVER Shaver does not 1. Travel lock is activated. 1. Press the on/off switch for 3 seconds start when 2. This appliance can to unlock the shaver. pressing the only be operated 2. Unplug the shaver. start button.
Page 33
Shaver turns off Foil and cutter are worn – Replace Foil & Cutter cassette. with fully which requires more – Regularly oil the shaving system, charged battery. power than the motor especially when cleaning with water can deliver. The only. appliance turns off.
Page 34
This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance.
Page 35
Our Warranty applies in all States and Territories of Australia and in New Zealand and is in addition to any mandatory statutory obligations imposed on Procter & Gamble Australia Pty. Ltd., its distributors and its manufacturer. Our Warranty does not purport to exclude, restrict or modify any such mandatory statutory obligations.
Page 36
Australian Consumer Service (free call): 1 800 641 820 New Zealand Consumer Service (free call): 0 800 108 909 Australian & New Zealand Service Agents VICTORIA & TASMANIA NEW SOUTH WALES & ACT Statewide Services Pty Ltd trading Faulder Appliance Services Pty Ltd as J A Appliances Shop 4, 17-19 Hossack Avenue...
Need help?
Do you have a question about the 9 SERIES and is the answer not in the manual?
Questions and answers
if we have a broken one, is there a way to send it to you to fix it
Yes, Braun 9 Series shavers can be sent in for repair if they exhibit defects in material or workmanship within the two-year limited warranty period, excluding the foil and cutter block. The shaver must be shipped in its original packaging with the original sales receipt. Users should call 1-800-BRAUN-11 (1-800-272-8611) to be referred to the nearest authorized Braun Service Center.
This answer is automatically generated
where is the model number listed
The model number for the Braun 9 Series is located on the device and is part of the series identifiers such as 9297cc, 9296cc, 9295cc, 9292cc, 9291cc, 9290cc, and 9280cc. It is also mentioned in the manual as "Type 5791."
This answer is automatically generated