3-prong grounded plug. » Do not put any object into open- » Use only BISSELL cleaning » Do not leave appliance when it is ings. Do not use with any opening products intended for use plugged in.
Thanks for buying a BISSELL CrossWave™ We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your multi-surface cleaner works as well in two years as it does today, so this guide has tips on using (pages 6-8), maintaining (pages 9-13), and if there is a problem, troubleshooting (page 14).
Page 4
Getting to Know Your CrossWave™ Upper Handle Foot SmartClean Fingertip Controls Solution Spray Trigger Float Stack Quick Release Cord Wrap Easy Remove Brush Window 10 Clean Water Tank Integrated Carry Handle Lower Cord Wrap Dirty Water Tank Easy Clean Storage Tray www.BISSELL.com...
Assembly WARNING Do not plug in your CrossWave™ until you are familiar with all instructions and operating procedures. Your BISSELL CrossWave™ machine comes • Handle in three easy to assemble components and • Body does not require any tools to assemble. The •...
Page 6
Screw the cap back onto the clean water tank. A few notes about filling the clean water tank: • Fill with warm (140°F/60°C MAX) tap water and add the appropriate BISSELL solution. DO NOT USE BOILING WATER. DO NOT HEAT WATER OR TANK IN MICROWAVE. www.BISSELL.com...
TIP: For overly challenging and stuck-on messes on your hard floors, activate the RUG mode and hold your CrossWave™ over the mess. Using short passes while holding the trigger allows the multi-surface brush to go to work. www.BISSELL.com...
Page 8
TIP: For the most thorough clean, make 4 wet passes and 4 dry passes over each area you clean on your rugs. ATTENTION Do not over wet carpet. Be careful not to run over loose objects or edges of area rugs. Stalling the brush may result in premature belt failure. www.BISSELL.com...
Page 9
Hand wash the vacuum filter and screen Rinse the float located at the bottom with warm water and mild detergent. of the top of the dirty water tank. www.BISSELL.com...
Page 10
Angle the dirt tank back into body of Once parts are dry, reassemble and machine inserting bottom first. Then replace the top of dirty water tank. tilt the top of the dirt tank toward the machine and push into place until you hear a click. www.BISSELL.com...
Page 11
Then press the Then lock the pull tab into place by window back into place until you hear pressing downward. a click. www.BISSELL.com...
Page 12
Repeat as needed. Pull brush roll out by grabbing the Place the brush roll upright in the Brush brush roll tab and pulling upward. Roll Drying Tray to dry. www.BISSELL.com...
Put the unit away in a closet or basement until the next use. Store cleaner in a protected, dry area. Since this product uses water, it must not be stored where there is a danger of freezing. Freezng will damage internal components and will void the warranty. www.BISSELL.com...
Service If your BISSELL product should require service: Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.
Need help?
Do you have a question about the CROSSWAVE 1785 SERIES and is the answer not in the manual?
Questions and answers
Can I get a new clean water tank for my multifunction cleaner