Adim Connections And Configuration; Dvr Configuration (See Dvr Manual); Intuikey Keyboard And Serial Hub Connections; Adim Pc Is Pre-Configured As Follows - Philips ADIM ADM0101 Installation Instructions Manual

Philips integration solution installation instructions
Table of Contents

Advertisement

4
ADIM CONNECTIONS AND
CONFIGURATION
NOTE: The installer should be familiar with the Allegiant CCTV
control system and Windows-based software, and have a general
knowledge of networking.
4.1

DVR Configuration (See DVR manual)

Configure each DVR with a unique IP address
• Ensure valid IP addresses are configured
• Set the DVRs recording parameters
• Ensure the Hi-Q's password is set to 1234 (this is the default
password)
4.2

IntuiKey Keyboard and Serial Hub Connections

• Connect each IntuiKey Keyboard to the Allegiant via an
RS-485 cable (not supplied).
• Connect each IntuiKey Keyboard to the Serial Hub via a null
modem cable (a 15-foot cable is supplied).
• Connect the serial hub to the network via an ethernet cable
(2 are supplied).
IMPORTANT:
• The serial hub must be on the same network segment as the
ADIM PC.
• If the distance from your Keyboard to the Serial Hub exceeds
RS-232 limitations (50 feet), use a modem or additional Serial
Hub to extend the distance. (See Appendix B for the RS-232
pin out details.)
Rear View of the Serial Hub
4.3
*Not Used; On the Serial Hub, keyboard cables can be
connected to Ports 1 through 6, Ports 7 & 8 are not used.
IMPORTANT:
configurations in Sections 4.4 & 4.5) for future reference.
4.4
• Connect the camera to the Primary DVR inputs and loop
video to the Allegiant inputs.
• Connect the MON A output of the Primary DVRs to
Allegiant inputs.
Figure 4.1 shows the relationship of the Primary DVR outputs and
Allegiant inputs to the DVR Configuration page of the ADIM.
4.5
• Connect the Allegiant Monitor Outputs to the Backup or
Review DVR video inputs.
• Connect the MON A output of the DVRs to an Allegiant
input.
Inputs
PHILIPS
ALLEGIANT Video Matrix
32
101 102
234 536
Loop Out Video
Mon A
2
4
3
1
PHILIPS
PHILIPS
PHILIPS
PHILIPS
32
1
2
3
4
Figure 4.1
10

ADIM PC is pre-configured as follows:

Serial Hub's
Physical Port
1
2
3
4
5
6
7
8
Please make note of your connections (COM port

Primary DVR Connections

Backup DVR and Review Monitor Connections
(Optional)
101
102
234
536
PC COM Port
5
6
7
8
9
10
11*
12*

Advertisement

Table of Contents
loading

Table of Contents