NAD M50.2 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. MP3 Player
  5. M50.2
  6. Owner's manual
NAD M50.2 Owner's Manual

NAD M50.2 Owner's Manual

Digital music player
Hide thumbs Also See for M50.2:

Advertisement

Table of Contents

See also: Service Manual
M50.2
®
Digital Music Player
© NAD M50.2
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD M50.2

Summary of Contents for NAD M50.2

  • Page 1 M50.2 ® Digital Music Player © NAD M50.2 Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. NOTE TO CATV SYSTEM INSTALLER FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO This reminder is provided to call the CATV system installer’ s attention to Section 820-40 of EQUIPMENT. the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
  • Page 3 IMPORTANT SAFETY INSTRUCTIONS Battery must not be exposed to excessive heat such as sunshine, fire or the CANADA NOTICE like. “This Class B digital apparatus complies with Canadian ICES-003. ” This device complies with Industry Canada license-exempt RSS-210. Operation is subject to the following two conditions: (1) this device may not cause Interference, WARNING and (2) this device must accept any interference, including interference that may...
  • Page 4 Serial number : ........RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) The model and serial number of your new M50.2 are located on the back of the cabinet. For your future convenience, we suggest that you record these numbers here:...

  • Page 5: Getting Started

    CONNECT TO NETWORK • you move or need to transport your M50.2, this is the safest container to Using an Ethernet cable (not supplied), connect one end to M50.2’s LAN use. We’ve seen too many otherwise perfect components damaged in port and the other end directly to your Wired home network or router.

  • Page 6: Identification Of Controls

    IMPORTANT NOTES For the o (Standby) button to activate, the following must occur: a The supplied power cord from the M50.2 must be plugged in to a power source. b The rear panel POWER switch must be set to ON.

  • Page 7: Front Usb

    Reboot (Yes/Cancel) Yes: M50.2 will power off and restart again. Cancel: Current condition is retained. Factory Reset Yes: M50.2 will be restored to its factory default settings. Cancel: Current condition is retained. Firmware Version Current firmware version is shown.

  • Page 8: Rear Panel

    5 RS 232 NAD is a certified partner of AMX and Crestron and fully supports these external devices. Check out the NAD website for information about AMX and Crestron compatibility with NAD. Contact your NAD audio specialist for more information.

  • Page 9: Ac Mains Input

    +12V DC input jack using a mono cable with 3.5mm male plug. • This output will be 12V when the M50.2 is ON and 0V when it is either OFF or in standby mode. +12V TRIGGER IN With this input triggered by a 12V DC supply, the M50.2 can be switched ON remotely from Standby Mode by compatible devices such as amplifiers, preamplifiers, receivers, etc.

  • Page 10: Operation

    OPERATION MAKING THE MOST OF YOUR M50.2 Download the BluOS Controller App from the respective App stores of Apple iOS devices (iPad, iPhone and iPod), Android devices, Kindle Fire and Windows or Mac desktops. Launch the BluOS Controller App and explore everything from your streaming music services, internet radio stations, networked music collections and favorites with quick and easy single-search discovery.
  • Page 12 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents