Silent Arming/Disarming; Voice (Talking) Disable/Enable Function; Arming In Transport Mode; Energy Saving Security Mode - Hawk x60 User Manual

Press the button, indicator lights will flash once and the system will be armed. If the motion detec-
tion sensor is triggered in silent arming mode for first time, indicator lights flashes slowly. System will
revert to normal arming mode automatically, when shaken again. To disarm in silent arming mode
press the button. Press the

VOICE (TALKING) DISABLE/ENABLE FUNCTION

(Factory default voice enabled)
If user wants to disable the voice function, press
the voice is turned off, and replaced with siren bleep. To enable the voice function, press
again at the same time, system will say: "Hawk system disarmed", the voice is turn on again.

ARMING IN TRANSPORT MODE

(Temporary Sensor By pass)
After pressing button to arm the system, press
flash once, indicating shock sensor and auxiliary sensor are both bypassed; now the motorbike can
be transported freely. To turn on the shock sensor and auxiliary sensor, press
be back to normal arming status.

ENERGY SAVING SECURITY MODE

Turn the ignition switch OFF, Press the button button simultaneously; system will say: "Hawk
System Armed", indicators will flash twice. System will enter automatically Energy saving mode
after 3 seconds.
In the Energy Saving Security mode, if the engine switch on, warning alarm will continuously sound for
30 seconds and the engine will be immobilised. The indicator lights will not flash for energy saving.

ALARM REACTION

Once the system is heavily triggered, the alarm will sound and the indicators will flash for 30 sec-
onds before switching off automatically, and system will output negative signal for 30 seconds at the
same time (white wire).
To switch off alarm and stop the negative output signal, press the

EMERGENCY KEY RESET:

If the remote control is lost the owner can disarm the alarm with the key. Please refer to steps below:
1. Keep the ignition switch off position for 1 second.
2. Turn the ignition switch ON/OFF 5 times and it will disable alarm immediately.
Make sure that each ON/OFF sequence is completed in 1 second otherwise the system will ignore it.

SILENT ARMING/DISARMING

button to quit silent arming and back to normal arming mode.
and at the same time, siren chirp twice,
again once within 3 seconds, indicator lights
button on the transmitter.
and
again, the bike will
2