A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the KC550 or compatibility with the network, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
1. INTRODUCTION E. Notice of Radiated Emissions The KC550 complies with rules regarding radiation and radio frequency emission as defined by local regulatory agencies. In accordance with these agencies, you may be required to provide information such as the following to the end user.
3. TECHNICAL BRIEF 3. TECHNICAL BRIEF 3.1 KC550 Component Block diagram KC550 is composed with 5 different PCB part such as main PCB, Key PCB, Key FPCB, LCD FPCB and Flash FPCB/ The functional component arrangement is mentioned below diagram.
3. TECHNICAL BRIEF 3.3.6 GPIO map Over a hundred allowable resources, KC550 is using as follows except dedicated to SIM and Memory. KC550 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table. Table 5 S-GOLDradio GPIO pin Map...
3. TECHNICAL BRIEF 3.6 SIM interface KC550 supports 1.8V & 3V plug in SIM, SIM interface scheme is shown in (Figure 10). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-GOLDradio) and the SIM power supply enabled by BBP (_SIM_EN).
Need help?
Do you have a question about the KC550 and is the answer not in the manual?
Questions and answers