Table of Contents
Advertisement
LINK 7000 / CYBACK
Programming mode
For these two programs the RS cable must be connected on the RS232 port of
the J5 plug.
The transmission parameters must be programmed on the DNC with the same
values as for the test of the serial ports (see paragraph above). These same
values must be programmed on the PC.
If the transmission runs at 4800 baud, you can try to increase the transmission
speed at 9600 baud.
The RS 232 norm gives as limit 15m. By using a more important distance,
there is a risk of bad transmission and it will be necessary to diminue the
transmission speed.
Reminder: The transmission command can be given only from the PC side.
To permit the serial transmission with CYBACK:
Pass to programming mode.
! Call the TRANFER DNC < – > PC page.
! Introduce 2 in the TRANSFER field.
! Press the
key.
The display indicates STATUS RS232.
From this instant on, the DNC can receive data sent from the PC, provided
that the DNC is in programming mode.
In the other modes (auto, semi-auto or manual) the DNC doesn't respond, the
transmission is not accepted.
During the transmission the operator can leave the DNC on any page. It is not
necessary to display the transfer page.
The transfer mode remains memorized, even if the DNC is disconnected from
power supply. It has to be re-programmed if the mode has been changed (for
instance FLASH).
PC900/1200 and LINK7000
Use the conversion file SIXFAFIØ.XFR and followings.
TRANSFER
PAGE 55
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DNC 60 PS and is the answer not in the manual?
Questions and answers
Ayarlamada makinayi aç kapat yaptım ekrandan yazılar gitti nasıl düzeltebilirim
To fix the display issue on the CYBELEC DNC 60 PS after turning the machine on and off, follow these steps:
1. Switch the machine off and then on again.
2. Check the program to ensure safety factors are correctly set.
3. Verify that the axes can move in manual mode.
4. Compare the machine parameters with the written list to ensure they are correct.
If the issue persists, you may need to clear and reconfigure the machine parameters by:
1. Setting the following values:
- Clear variables zone: 1
- Clear punches-dies zone: 1
- Clear machine parameters zone: 1
- EXECUTION CODE: 817
2. Pressing the key twice to confirm.
After clearing, reconfigure the DNC 60 before using it again. If using an external system (CYBACK via RS232) for data re-entry and the problem continues, delete all DNC contents and manually reprogram it via the keyboard instead of RS232.
This answer is automatically generated
@Mr. Anderson
Makinanı nasıl yeniden başlatıcam ekran yazıları gitti geri getiremiyorum
To restart the CYBELEC DNC 60 PS machine when the screen text is missing, follow these steps:
1. Switch the machine off, then turn it on again.
2. Check the program, ensuring the safety factors are correct.
3. Verify that the axes can be moved in manual mode.
4. Compare the machine parameters with the written list.
If the issue persists, consider clearing the machine parameters and reconfiguring the DNC 60 manually via the keyboard instead of using an external system like CYBACK via RS232.
This answer is automatically generated