Makita HK0500 Technical Information page 10

6. Grease
[ Grease exchange]
In exchanging Carbon brush, exchange Grease also.
1) Drive the Machine for several minutes for warming.
2) Referring to the above mentioned (2) Chuck repair and (3) Clunk housing, remove Clunk cap.
3) Directing the Machine top end upward, collect Grease in Clunk room, wipe it away with a cloth, and pour in 10 cc of
MAKITA grease R No.00.
NOTE: If you put Grease more than the defined quantity, a trouble such as wrong striking may occur. So, be careful
not to pour too much.
[ Place to apply Grease ] ( :applying place)
Apply Grease to the following positions to prevent early abrasion and being burnt
down.
1) Where MAKITA Grease is to be applied
Impact bolt:
O Ring,
X Ring,
All around Impact bolt
Striker:
O Ring,
All around Striker
Piston:
O Ring,
All around Piston