Network Interface - Sangfor IAM 2.1 User Manual

SANGFOR IAM v2.1 User Manual

3.5. Network Interface

Under Route mode, you can configure the network interfaces on this [Network Interface] page. If
it is in Bridge mode, [Multi-bridge], you can also configure the bridge here. As to other gateway
modes, the network interfaces are configured in [System] > [Gateway Mode].
[Network Interface] default configuration page is as shown below:
[LAN Interface]: Displays the information of LAN interface. Click the <Configure> button to
enter the corresponding configuration page.
If you are to configure multiple IP addresses, you can add the IP addresses that are to be bound;
click the <Next> button to get into the next page.
[VLAN]: [Enable] or [Disable] VLAN.
[VLAN Address List]: If the interface of the switch that is connecting to IAM gateway device has
applied Trunk, then configure the IP address and VID (VLAN ID) for the VLAN at the LAN
interface.
The VLAN function supports VLAN (802.1Q) networking environment. If the LAN interface of
the IAM gateway device is configured with 802.1Q-VLAN address, the LAN can connect to the
TRUNK interface of the layer 2 switch that supports VLAN, and data of different VIDs can be
37