Digital Set Top Box; Mains Adaptor; The Remote Control; Using The Remote Control - Philips Digital Set Top Box DTR210 User Manual

Digital Set Top Box

Front view
IR Receiver / Red LED, Normal Operation - off, Standby - on
Rear view

Mains Adaptor

Plug this into a 230V AC

The Remote Control

Using the Remote Control

To use the remote control, point it towards the front of
the set top box.
The remote control has a range of up to 7 meters from
the set top box at an angle of up to 60 degrees.
The remote control will not operate if its path is blocked.
Warning:
Sunlight or very bright light will decrease the
sensitivity of the remote control.
Mains adaptor
A mains power adaptor has been supplied for powering
this equipment. It has an integral cable terminated in a
power connector to plug directly into the 12V connector
on the back of the Digital Set Top Box. The adaptor is
shown on the right.
RF out
RF in Scart output
from Aerial connector for VCR
and DVD units
outlet socket
Scart output
connector for
TV
Power cable (1.5 m)
Power connector for connection to
Set Top Box
Plug the cable into the 12V DC connector on the rear
panel. Insert the adaptor body into a suitable mains outlet
socket.
Note that the only recommended way to disconnect the
Digital Set Top Box from the mains supply is to remove
the adaptor from the mains socket. If the mains socket is
fitted with a switch, this could be used instead.
Set Top Box
Power Supply Adaptor
Set Top Box rear panel
Power Supply in,
12 V DC
SPDIF
(Digital audio out)
To 230V AC
mains supply
+12V DC
ETTING TARTED
G S
7