Control Panel - Indicator Lights - AutoPets Litter-Robot Instruction Manual

Control Panel - Indicator Lights

Blue Light On: OK/Standby
The unit is OK and ready for your cat's next use.
Blue Light Flashing: Waste Drawer is Full
The Waste Drawer is approaching full (see page 20).
Remove the waste, install a new liner, then press Reset
to cancel the flashing light and adjust the Cat Sensor.
Blue and Yellow Lights On: Sleep Mode
The Litter-Robot is in 8 Hour Sleep Mode (see page 22).
Yellow Light On: Cycling/In Use
The Litter-Robot is cycling (Clean or Empty cycle).
Yellow Light Flashing: Cycle Interrupted
A yellow light flashing slowly (about once per
second) indicates a cycle has been interrupted by one of
the following:
 While cycling, if the Cat Sensor is activated by a cat
entering the Globe, the unit will stop and the yellow
light will flash. The unit will start to cycle again 15
seconds after your cat has left the Globe.
 If the Bonnet is removed while cycling or while the
Globe is at the Home position, the unit will stop (if
previously cycling) and the yellow light will flash. The
unit will resume its previous function 5 seconds after
the Bonnet is replaced (see page 28-29).
A yellow light flashing quickly (about four times per
second) indicates a cycle has been interrupted by the
Anti-Pinch Safety Feature (see page 30). While
cycling, if a potential pinch condition is detected, the
Globe will stop and reverse direction for 2 seconds. The
yellow light will begin flashing quickly, awaiting your
action. Once the blockage is cleared, press any button to
return the Globe to the Home position.
Toll Free: 877-250-7729
17
www.Litter-Robot.com