Download Print this page
Sealey RS131.V3 Instruction Manual
Sealey RS131.V3 Instruction Manual

Sealey RS131.V3 Instruction Manual

Roadstart emergency power packs

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Warning:
Instruction
Explosive
Manual
Material
1. SAFETY
Read and understand the general safety and operating instructions before use. The following information is intended to help you
keep the product in top working order.
NOTE – The battery in this unit is a consumable item and its ability to accept charge will reduce over time. We will warranty it
against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery even if it is less than one year old.
You can help prolong the lifecycle of the battery by following a few simple guidelines.
Plug in your new Roadstart to the mains transformer and make an INITIAL charge lasting 38 hours.
Ensure the unit is fully charged before storage.
DO NOT leave the Roadstart for longer than 2 months without putting it on charge.
DO NOT attempt to start a vehicle when the Roadstart battery voltage is reduced to less than 7Volts.
DO NOT drop or roughly handle the Roadstart – this will break or disjoin the battery terminals rendering the battery useless and the
warranty void.
DO NOT use any other charger, other than the one supplied, to recharge the battery.
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on
engines.
1.1. PERSONAL PRECAUTIONS
Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working

near a lead-acid battery.
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.

W ash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,

clean running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit

current high enough to weld a ring or the like to metal, which may cause severe burns.
1.2. IMPORTANT SAFETY INSTRUCTIONS
Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.

Keep the unit in good working order and condition. Replace damaged parts immediately.

Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.

T he RoadStart must only be opened and checked by qualified service personnel. DO NOT disassemble the unit for any reason.

Keep children and unauthorised persons away from the work area.

Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.

I f the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.

When not in use re-charge every two months.

DO NOT smoke or allow a spark, or flame in the vicinity of the battery or engine.

DO NOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.

DO NOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and

cause personal injury and damage to property.
DO NOT charge or boost a frozen battery.

DO NOT use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible

personal injury.
DO NOT pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.

DO NOT operate in vicinity of flammable liquids or gases.

DO NOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.

DO NOT use this product to perform a task for which it is not designed.

DO NOT store the unit in damp or wet locations or where the temperature may exceed 50°C.

DO NOT submerge the unit in water.

© Jack Sealey Limited
INSTRUCTIONS FOR
ROADSTART EMERGENCY POWER PACKS
MODEL NO'S:
Wear eye
Warning:
Protection
Corrosive
substance
IMPORTANT WARRANTY INFORMATION: KEEP YOUR ROADSTART HEALTHY
Original Language Version
RS131.V3, RS132
Wear
Warning:
Protective
Electricity
Gloves
Use in
Protect
From
Well
Rain
Ventilated
Areas
RS131.V3 RS132 | Issue 5(I) 04/01/16
Keep away
from sources
of ignition:
Battery could
explode

Advertisement

loading

Summary of Contents for Sealey RS131.V3

  • Page 1 RS131.V3, RS132 MODEL NO’S: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    We recommend that an RCD (Residual Current Device) is used with all electrical products. It is particularly important to use an RCD with portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You can obtain a Residual Current Device through your Sealey dealer. You must read and understand instructions concerning electrical safety.
  • Page 3: Charging Instructions

    RECHARGING WITH THE DC CHARGING CABLE IMPORTANT: Always ensure that the vehicle voltage matches the voltage of the Roadstart unit. Do not operate any of the units functions during the charging process. Original Language Version RS131.V3 RS132 | Issue 5(I) 04/01/16 © Jack Sealey Limited...
  • Page 4: Operation

    Press the battery check button. If the green lights do not illuminate the unit must be charged before it can be used for jump starting. 6.5.3. Ensure that all cables are clear of moving belts and rotating fans. 6.5.4. Turn the side switch to the ON position. Original Language Version RS131.V3 RS132 | Issue 5(I) 04/01/16 © Jack Sealey Limited...
  • Page 5: Using The Compressor

    Switch on the compressor using the switch on the unit (see fig.2-16) and monitor the pressure on the air pressure gauge (see fig.2-15). 7.2.6. When the desired pressure is reached, turn off the compressor, rotate the connector lever to the upright position and remove it Original Language Version RS131.V3 RS132 | Issue 5(I) 04/01/16 © Jack Sealey Limited...
  • Page 6: Battery Removal/Disposal

    Check accessory current draw. Can I replace the Yes, but note that the batteries are not internal batteries? covered by warranty as they are consumable items Original Language Version RS131.V3 RS132 | Issue 5(I) 04/01/16 © Jack Sealey Limited...
  • Page 7 Contact your local solid waste authority for recycling information. Battery Removal Undo the eleven screws which hold the casing together and pull the casings apart. Disconnect the battery leads. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.

This manual is also suitable for:

Rs132