Samsung products are not designed, intended, or use of the information contained herein. authorized for use as components in systems Samsung reserves the right to make changes in its intended for surgical implant into the body, for other products or product specifications with the intent to...
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 Revision History Revision No Description of Change Refer to Author(s) Date - Master Copy 2008-03-07 Lee Jongpill NOTE: Revised parts are written in blue. Preliminary product information describe products that are in development, for which full characterization data and associated errata are not yet available.
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 CONTENTS INTRODUCTION........................... 6 ..................................6 VERVIEW FEATURE ..................................7 KERNEL COMPILATION FOR LCD DRIVER ..................8 ...............................8 ERNEL OMPILATION Preliminary product information describe products that are in development, for which full characterization data and associated errata are not yet available.
Page 5
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 Figures FIGURE - S3C6410 B ................. 6 LOCK IAGRAM OF ISPLAY ONTROLLER FIGURE - D ............................ 9 EVICE RIVERS FIGURE - G ..........................9 RAPHICS SUPPORT FIGURE - S ....................10 UPPORT FOR FRAME BUFFER DEVICES FIGURE –...
Section 1.2, “Features” 1.1 Overview The LCD controller in the S3C6410 consists of the logic for transferring LCD image data from a local bus of the POST Processor or a video buffer located in system memory to an external LCD driver interface.
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 1.2 FEATURE Supports 3 types of Video Output Interface : RGB Interface, Indirect I80 Interface, TV Encoder Interface(NTSC, PAL standard) Supports 1, 2, 4 or 8-bpp (bit per pixel) palettized color Supports 16, 18 or 24-bpp non-palettized color...
In this Chapter, you will understand how to Kernel compile for LCD Driver. 2.1 Kernel Compilation In this chapter, you will understand the initial steps for Installing S3C6410 BSP on Linux operating system. Kernel source is compressed by the name of “s3c-linux-2.6.21_rel-x-x-x_yymmdd.tar.bz2”. Extract this bz2 file by executing the following command.
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 Select “Device Drivers” from “Main Menu”. FIGURE - Device Drivers Select “Graphics support” from “Device Drivers”: FIGURE - Graphics support Preliminary product information describe products that are in development, for which full characterization data and associated errata are not yet available.
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 Select “Support for frame buffer devices” from “Graphics support”: FIGURE - Support for frame buffer devices Select “S3C SMDK LCD framebuffer support” from “Graphics support” and select LCD type: Type of LCD panel S3C SMDK LCD framebuffer support LTV350QV LTV350QV (3.5 inch LCD)
Choose double buffering support : double buffering NOT supported or double buffering supported ☞ S3C6410 H/W support double buffer for WIN0 and WIN1. But device driver on Linux support it only on WIN0. Double buffer on WIN1 is not implemented.
S3C6410 INSTALLATION MANUAL FOR LCD V1.2 FIGURE - Advanced low level driver options Select “Exit” and then “Yes” to save your new kernel configuration. FIGURE - Saving New Kernel Configuration Execute the following commands on your host PC, the Kernel image will be created in “s3c-linux- 2.6.21/arch/arm/boot/”...