Irc-6 Infrared Remote Control - Chauvet Freedom Stick User Manual

IRC-6 Infrared
Remote
Control
Page 16 of 22
The Freedom Stick is compatible with the IRC-6 infrared remote control from Chauvet
DJ. To activate IR mode, follow the instructions below:
Individual products:
Each product will respond independently to the IRC-6 remote.
1. Press <MENU> repeatedly until Set appears on the display.
2. Press <ENTER> to accept.
3. Press <UP> or <DOWN> to select ON.
4. Press <ENTER>.
5. Press <MENU> repeatedly until C-- or P – (COLOR/Auto Programs) appears on
the display.
6. Press <ENTER> twice to accept.
Master/Slave multiple products:
Control 1 product with the IRC-6, have all other products respond to the first product.
Master product:
1. Press <MENU> repeatedly until Set appears on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ON.
4. Press <ENTER>.
5. Press <MENU> repeatedly until S-tr appears on the display.
6. Use <UP> or <DOWN> to select ON.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select dtCH (DMX Transmit Channel).
9. Press <ENTER>.
10. Use <UP> or <DOWN> to select the transmitting channel that the slave products
are receiving.
11. Press <ENTER>.
12. Press <MENU> repeatedly until C-- or P – (COLOR/Auto Programs) appears on
the display.
13. Press <ENTER> twice to accept.
Slave products:
1. Press <MENU> repeatedly until Set appears in the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until OFF appears on the display.
4. Press <ENTER>.
5. Press <MENU> repeatedly until S-tr appears on the display.
6. Press <ENTER>.
7. Press <UP> or <DOWN> to select ON.
8. Press <ENTER>.
9. Press <UP> or <DOWN> until the display shows drCH (DMX Receive Channel).
[Display should read dr_#]
10. Press <UP> or <DOWN> until the same channel number is shown as used in the
master unit.
11. Press <ENTER>.
12. Press <MENU> repeatedly until SLA appears on the display.
13. Press <ENTER>.
14. Press <UP> or <DOWN> until SLA2 appears on the display.
15. Press <ENTER>.
16. Press <MENU>until 3-CH (3 channel DMX mode).
17. Press <ENTER>.
[Display should read d###]
18. Press <UP> or <DOWN> until display reads D_ _1
19. Press <ENTER>.
This unit will now respond to the master unit that is being controlled by the IRC-6.
20. Repeat the above steps with all remaining slave units. Setting the desired slave #
(1-4) as needed in step 15.
All slave units will now respond to the master unit being controlled by the IRC-6.
Freedom Stick User Manual Rev. 3