4258 KV460 motor coupled with our Predator high quality 70A ESC completes a stronger more powerful system. All servos are now metal gear digital servos. Furthermore, this 1500mm P-47 adopts the latest 2016 FMS electric retract. The 2016 FMS electric retract gets a commendable upgrade on both appearance and performance.
Wingspan: 1500mm (59.0in) Overall Length: 1270mm (50.0in) Flying Weight: Around 3700g (59.3oz) Motor Size: Brushless 4258-KV460 Wing Load: 92.5 g/dm² (0.21oz/in²) Wing Area: 40.0 dm² (620 sq.in) ESC: 70A Servo: 17g metal digital x 6, 9g metal digital x 3 Contents of Kit Before assembly, please inspect the contents of the kit.
Horizontal Tail Installation 1. Slide the horizontal tail tube into the hole in the rear of the fuselage. 2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the control horn faces down. 3. Secure the two horizontal tail pieces in place using the 4 included screws. KA3.0×15 fig1 fig2...
Page 6
Main Wing Installation 1. Slide two tubes into the fuselage then install both wings over the wing tube and into the wing slot of the fuselage. Notice: The connectors on both side should be attached precisely and firmly. fig5 Secure the wings on the fuselage using 4 screws inside the top of fuselage. Make sure it is tightened enough HKM3×65 fig6...
Page 7
Drop Tank, Rocket Tubes, Bomb, Machine Guns and Antenna Installation 1.Slide the Rocket Tubes and drop tank into the rails. into the pocket. 2.Carefully apply foam safe CA to the base and side of the Bombs pocket and place the bombs 3.Carefully apply foam safe CA to the base and side of the machine guns pocket and place the machine guns into the pocket.
Battery and radio installation Apply the hook tape to the cable end of the battery (fig8). Slide the battery into the battery hatch with the power supply cable toward the rear end of the plane and the hook tape facing the bottom of the battery hatch. Note: You may need to relocate the battery position to achieve the correct CG for your model.
Get your model ready to fly Important ESC and model information The ESC included with the model has a safe start. If the motor battery is connected to the ESC and the throttle stick is not in the low throttle or off position, the motor will not start until the throttle stick is moved to the low throttle or off position.
Check the control throws The suggested control throw setting for FMS MODEL are as follows (dual rate setting): Tips: On first flight, fly the model in low rate. The first time you use high rates, be sure to fly at low to medium speeds.
Install the propeller and spinner Assemble the spinner and propeller as shown below. Check the C.G. (Center of Gravity) When balancing your model, adjust the motor battery as necessary so the model is level or slightly nose down. This is the correct balance point for your model. After the first flights, the CG position can be adjusted for your personal preference.
Before flying the model Find a suitable flying site Find a flying site clear of buildings, trees, power lines and other obstructions. Until you know how much area will be required and have mastered flying your plane in confined spaces, choose a site which is at least the size of two to three football fields - a flying field specifically for R/C planes is best.
Flying your model Take off While applying power, slowly steer to keep the model straight. The model should accelerate quickly. As the model gains flight speed you will want to climb at a steady and even rate. P-47 will climb out at a nice angle of attack (AOA).
Spare parts list content Fuselage FMSPT101 FMSPT102 Main Wing Set FMSPT103 Horizontal Stabilizer FMSPT104 Cowl FMSPT105 Spinner FMSPT106 Canopy Hatch FMSPT107 Plastic Scale Cockpit FMSPT108 Bomb FMSPT109 Oil Tank FMSPT110 Rockets FMSPT111 Antenna FMSPT112 Main Landing Gear Set FMSPT113 Main Landing Gear System FMSPT115 Main Landing Gear Door FMSPT116...
Need help?
Do you have a question about the 1500MM P-47 RAZORBACK and is the answer not in the manual?
Questions and answers