Changing The Engine Oil; Recommended Engine Oil; Quantity Of Engine Oil - Derbi GPR125 Workshop Manual

3 - MAINTENANCE

CHANGING THE ENGINE OIL

1. First remove:
* The bottom fairing (to gain access to the drain plug and the
oil filter).
2. Start up:
- The engine and leave to warm up for a few minutes.
3. Stop:
- The engine and place a container under it.
4. Remove:
- The drain plug (1).
- The sieve (pre-filter) to be found inside.
- The oil filter cover (2).
- The oil filter.
- The filler cap.
N.B.
5. Drain:
- The oil out completely.
6. Refit:
- The sieve (pre-filter). Clean it before refitting.
- The drain plug (1).
- The NEW oil filter (4).
- The spring (3).
- The oil filter cover (2)
Pre-filter cap:
24-30 N.m (2,4-3,0 Kgf.m)
Oil filter cap:
24-26 N.m (2,4-2,6 Kgf.m)
N.B.

RECOMMENDED ENGINE OIL

AGIP TECH 4-stroke 10W-40 or equivalent.

QUANTITY OF ENGINE OIL

1.150 ml
7. Fit:
- The filler cap (5).
8. Check:
- The oil level in the engine.
See the section entitled: "INSPECTING THE ENGINE OIL LEVEL"
69
TO AID IN DRAINING THE OIL, RE-
MOVE THE FILLER CAP.
APPLY A THIN FILM OF OIL TO THE
DRAIN PLUG AND FILTER COVER
O-RINGS.
ALWAYS RENEW THE FILTER WHEN
PERFORMING AN OIL CHANGE.
1
2
3
2
4
5