Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Mitsubishi Wi-Fi Control
Summary of Contents for Mitsubishi Wi-Fi Control
- Page 1 INSTALLATION GUIDE...
-
Page 2: Setting Information
Wi-Fi Control Minimum Requirements for Operation: • Compatible WPS router, capable of WPA2-AES encryption. The wireless network coverage must include the heat pump installation location; • A PC or Tablet/Smartphone that is iOS/Android compatible; • A compatible Mitsubishi Electric Heat Pump with a MAC-559IF-E Adaptor. - Page 3 8 of this installation guide. Register Your Heat Pump(s) Thank you for choosing a Mitsubishi Electric Heat Pump with Wi-Fi Control. Once your adaptor is installed, either download the app (search term: Mitsubishi Electric) or visit our website to register your heat pump(s).
- Page 4 Wi-Fi Control: Installation Instructions Information for installers: The following steps explain how to connect the MAC-559IF-E Adaptor to a Mitsubishi Electric Heat Pump. EQUIPMENT REQUIRED FOR INSTALL: MAC-559IF-E WPS Enabled Wi-Fi Tools to remove Adaptor Router Installation cover of indoor...
- Page 5 Remove the cover of the indoor Locate the CN105 port* on the unit, the cable terminal, and the main control board and connect cover to the control board. the MAC-559IF-E Adaptor. Reassemble the indoor unit and Run the cables down the back of restore power to the system.
- Page 6 Wi-Fi Control: Installation Instructions Information for users: The following steps explain how to connect the MAC-559IF-E Adaptor to a router. KEY (LED LIGHTS): FLASHING Check Wi-Fi and WPS are enabled Activate WPS mode on your router. on your router. The connection...
- Page 7 4 minutes. You can now download the If LED 2 (orange) lights up at any Mitsubishi Electric Wi-Fi Control stage there may be a problem. App and control your heat pump Check the troubleshooting section via Wi-Fi.
-
Page 8: Safety Instructions
New Zealand requirements for EMC smoke generation, or fire. and electrical safety. • Mitsubishi Electric components or other • Do not connect the Wi-Fi Adaptor to earth designated components must be used for inside the heat pump. - Page 9 Third party Wi-Fi Adaptors cannot connect to Mitsubishi Electric’s Wi-Fi service. Mitsubishi Electric is not responsible for any (i) under performance of a system or any product; (ii) system or product fault; or (iii) loss or damage to any system or product; which is caused by or arises from connection to and/or use of any third party Wi-Fi Adaptor or any third party Wi-Fi service with Mitsubishi Electric equipment.
-
Page 10: Product Introduction
Product Introduction Item Description WPS switch Activates WPS RESET switch Resets the system and ALL settings LED1 (Green) Shows the wireless communication state LED2 (Orange) Shows the MAC-559IF-E state LED3 (Green) Shows the local communication state Parts Adaptor unit Optional screw Optional screw Optional Fastener (for... -
Page 11: Troubleshooting
• Your router is compatible with the adaptor. For a list of compatible routers or if you are still experiencing issues connecting your router to the Wi-Fi Adaptor, please contact your local Mitsubishi Electric Office, as listed on the back cover of this guide. -
Page 12: Contact Details
Contact Details Mitsubishi Electric New Zealand Mitsubishi Electric Australia www.mitsubishi-electric.co.nz/wifi www.mitsubishielectric.com.au/wifi SYDNEY WELLINGTON HEAD OFFICE HEAD OFFICE 1 Parliament Street 348 Victoria Road PO Box 30772 Rydalmere Lower Hutt 5040 NSW 2116 Phone: 0800 639 434 Phone: 1300 728 119...
Need help?
Do you have a question about the Wi-Fi Control and is the answer not in the manual?
Questions and answers