Setting The Touch Drivers (Serial Touch Monitors Only) - AMX TPI-PRO-2 Operation/Reference Manual

FIG. 30 Resolution Setup page
5.
Press and hold the RESOLUTION button to save the resolution setting and exit the Resolution Setup
page.
When the new output resolution is applied, there may be some shifting of the default
Main page, as it was developed for 1280 x 1024.

Setting the Touch Drivers (Serial Touch Monitors Only)

After matching the resolution between the TPI-PRO/DVI and panel/monitor, the next step is to select the
necessary touch drivers from the driver set provided by the TPI-PRO/DVI.




1.
Press the TOUCH pushbutton on the front panel to open the Panel Information page (FIG. 31).
2.
Press the front panel TOUCH button to cycle through the list of available Touch Input Drivers.
TPI-PRO/DVI (Total Presentation Interface)
This step only applies to serial touch monitors, as USB monitors are automatically detected.
The touch drivers are set when you connect the TPI-PRO/DVI to a touch monitor.
The default Touch Input Driver is EloTouch
If you are using a non-touch monitor, set the Touch Input Driver to NullTouch.
Configuring the TPI-PRO/DVI
®
.
35