Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AMICUS EPO.D1-4
- Page 2 Please, read and follow the installation and operating instructions carefully, to ensure the long life and reliable operation of this appliance. Kospel S.A. may make minor changes if necessary, in the appliance, that will not be shown in the operating instruction, so long as the main features of the heater remain the same.
-
Page 3: Technical Data
The EPO.D provides hot water wherever it is required whether it is in the home, in a workshop, a public facility Description or in a laboratory. It is compatible with most taps available in the market. This pressure type heater has to be installed with inlet and outlet pipes at the top of the heater. -
Page 4: Installation
Recommendations Installation as an economy measure the he- ater should be installed close to the most frequently used tap; Picture 1 View the appliance can be connected to a cold water supply pipe This appliance should be instal- only; led and started-up by a profes- a non-return valve cannot be in- sional person. - Page 5 6. The appliance is set at single phase supply (it is equipped with a bridge[M1] connecting terminal clamps U and V).The single phase electric connection should be made according to the diagram 4a Electric connection Diagram 4 a - electric connection to the 1-phase installation electric connection to the 3-phase installa- tion...
-
Page 6: Initial Start-Up
1. Cut off electric supply. Initial start-up 2. Open the hot water tap to vent the installation (15-30 seconds). 3. Switch power supply on. The reccommended maintenance needs to be repeated each time after a decay of water. If the water installation is not vented the appliance may be damaged. -
Page 7: Maintenance
The appliance has a differential pressure switch [2] (picture 8). It switches Operating heating when there is a proper water flow through the heater. There are two indicators (LEDs) on the case: green - power supply, - heating. Chart 6 Characteristics The characteristics (picture 6) shows dependence between temperature rise and flow rate per minute. - Page 8 This heater has an overheating Construction protection: its over-temperature cut-out goes off (shuts off power supply) when the temperature in the heating box [1] goes over 95 C. Once the cut-out gets off, further operation is not possible. Diagram 8 Construction [1] - heat exchanger [2] - differential pressure switch [3] - safety temperature limiter...
- Page 9 Diagram 9 Wiring diagram E1 - heating box BV - differential pressure switch F1 - safety limiter X1 - terminals A1 - indicator board H1 - power supply indicator H2 - heating indicator If you notice any of the following signs of improper work, follow the instructions below: Faults the light indicators on the case a fault in the power supplies (for instance a fuse)
-
Page 10: Set Contents
EPO.D1 - 1 piece Set contents Gasket - 2 piece Filter - 1 piece Fixing screw with a pin - 2 pieces Spanner for regulation - 1 piece This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and know- ledge, unless they have been...
Need help?
Do you have a question about the EPO.D1-4 and is the answer not in the manual?
Questions and answers