Thermostat Functions; How To Join A Zigbee Network - Centralite 3157100 Installation Manual

The Heat (flame) mode symbol should illuminate and system should be blowing hot air.
 MODE button cycles between system modes: HEAT/COOL/E-H*/OFF
*E/H stands for emergency heat mode – this mode uses second-stage heat as a supplemental or back-up heat.
 FAN button toggles between Fan On Mode and Fan Auto Mode.
 HOLD button will enable Hold function which locks out all scheduled system changes. This
includes internal schedules and external schedules from a controller only if the controller
supports this.
 The CentraLite thermostat is intended to operate as part of a ZigBee HA network.
 The first step in the join process is to make sure the ZigBee HA controller is in a "Join
Network Mode" state (This state may vary depending on your ZigBee HA Controller)
 The CentraLite thermostat will attempt to join a ZigBee HA network upon power up
(as long as it has not already been joined to another ZigBee HA network).
 Upon successfully joining a ZigBee HA network the ZigBee Radio status indicator should
illuminate. (See Figure-4)
Figure-3 "Thermostat Operation"
Figure-4
6 | P a g e