Extron electronics mediaport 200 Setup Manual

MediaPort 200 HDMI and Audio to USB Scaling
Bridge • Setup Guide
The MediaPort 200 is an HDMI and audio to USB scaling bridge that interfaces between pro AV equipment and computer-based
video conferencing software. Incoming HDMI video is scaled and output via USB to a host computer. Bi-directional audio is
supported over the USB bus, including two stereo pairs from the PC for application playback and far-end communication audio,
and one stereo pair to the PC for local audio to be sent to the far end. Digital and analog audio inputs and outputs include a full
range of DSP optimization features, including filtering, EQ, ducking, compressors, and limiters. Setup and control are available via
front panel controls with an LCD menu, a front panel USB Configuration port, a rear panel RS-232 port, and a rear panel Ethernet
port. SIS (Simple Instruction Set
™
time control. The 1U high, half rack wide, 9.5 inches (24.1 cm) deep enclosure can be optionally mounted to a rack shelf, or under
or through furniture.
This setup guide provides step-by-step instructions for an experienced user to set up and configure a MediaPort 200.
NOTE:
For full installation, configuration, menu, connector wiring, and operation details, see the MediaPort 200 User Guide,
available at www.extron.com.
Installation

Rear Panel Features

100-240V 0.4A MAX
HDMI
LOOP OUT
50-60 Hz
A A
AC power connector
A
HDMI video input connector
B
C HDMI video loop out connector
Line level audio input connector
D
Mic/Line audio output connector
E
and phantom power LED
MediaPort 200 Rear Panel
Figure 1.
Mounting and Cabling the MediaPort 200
Disconnect power — Turn off or disconnect all equipment power sources.
1.
Mount the unit — (Optional) Mount the MediaPort 200 either in a rack using shelf mounting brackets such as Extron
2.
RSU 129 or RSB 129, or under furniture using furniture mounting brackets (MBU 125). A false half-rack plate can fit next to
the unit if desired.
Connect the HDMI input — Connect an HDMI video source to the HDMI input connector (see figure 1,
3.
included LockIt brackets to secure the connector in place.
®
Connect analog audio input —
4.
Connect an analog audio
z
input source to the 5-pole
captive screw Line audio input
connector ( ) for balanced or
D
unbalanced stereo audio. Wire
as shown at right.
Connect a balanced or unbalanced microphone or
z
mono line level input to the 3-pole Mic/Line captive
screw connector (
) commands and Windows
™
REF AUX
LINE MIC/LINE LINE
L R L R
+48V
INPUT OUTPUT
D D E E F F G G
F
G
H
I
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
). Wire as shown at right.
E
-based software configuration simplify initial configuration and real-
®
I1 I2 G O1 O2
I/O
LAN
USB
RS-232 +12V
RESET
Tx Rx G
REMOTE
H H I I K K L L
AEC REF and AUX audio output
connector
Line level audio output
connector
USB host connector
Reset LED
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
Tip
Ring
Sleeve
Balanced Audio Output
M M
0.1A
MAX
Reset button
J
LAN connector
K
L RS-232 and +12 V power
connector
Digital I/O connector
M
). Use the
B
Do not tin the wires!
Tip
Sleeve
Unbalanced Audio Output
inch (5 mm)
MAX.
1