Set Pir Sensitivity; Set Pir Triggering Interval - Covert Scouting Cameras Covert Extreme TLV User Manual

Covert Extreme
This parameter is effective and can be adjusted only when the device in the video
mode for the LIVE mode. Its value extends from 1 to 60 seconds with a step of one
second. The default value is 10 seconds. Press "◄" and "►" to decrease or increase the
value by 1 second.
The following shows how to set video length to 15 Seconds provided that the
previous value is 1 Second:
a) Press MENU to display the setting menu.
b) Press "▲" or "▼" to select Video Length.
c) Press "►" to increase to 15 Seconds.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to exit.

4.1.8 Set PIR Sensitivity

This parameter defines the sensitivity of the PIR. There are four parameters:
High, Normal, Low and PIR off. The default value is "Normal". The higher degree
indicates that the
Camera
pictures or recording more videos. It is recommended to use high sensitivity degree
in room or environment with little interference, and to use lower sensitivity for
outdoor or environment with lots of interference like hot wind, smoke, near window
The sensitivity of the PIR is strongly related to the temperature. Higher temperature
leads to lower sensitivity. Therefore we recommend the High setting for
temperatures exceeding 95 degrees Fahrenheit. Use the Low setting for temperatures
below 35 degrees Fahrenheit to reduce false triggers. For normal use of the camera,
the Normal mode is recommended and is the default setting.
The following shows how to set the PIR sensitivity as Low provided that the
previous option is Normal.
a) Press MENU to display the setting menu.
b) Press "▲" or "▼" to select Sensitivity.
Press "►" to select Low.
c)
Press OK to save the current setting and the option will be un-highlighted.
d)
Press MENU to return to info display.

4.1.9 Set PIR Triggering Interval

This parameter means that how long the PIR (Passive Infrared motion sensor)
will be disabled after each triggering in ON mode. During this time the PIR of the
device will not react to the motion of human (or animals). The minimum interval is 0
seconds meaning the PIR works all the time. The maximum interval is 1 hour,
meaning the PIR will be disabled for 1 hour after each triggering. The default value
is 1 minute. Press "◄" and "►" to decreases or increases the value.
The following shows how to set triggering interval time to 5 Minutes provided
that the previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press "▲" or "▼" to select PIR Interval.
c) Press "►" to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be un-highlighted.
4 Advanced Operations
is more easily to be triggered by motion, taking more
Page 10