Konwin Home GDSFP-1500AS Owner's Manual
  1. Manuals
  2. Brands
  3. Konwin Home Manuals
  4. Stove
  5. GDSFP-1500AS
  6. Owner's manual

Konwin Home GDSFP-1500AS Owner's Manual

Electric fireplace stove with heater
Hide thumbs
Table of Contents

Advertisement

Quick Links

Electric Fireplace Stove with Heater
OWNER'S MANUAL
Model No. GDSFP-1500AS
PLEASE SAVE THESE INSTRUCTIONS
WARNING: READ THIS OWNER'S MANUAL CAREFULLY BEFORE USE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GDSFP-1500AS and is the answer not in the manual?

Questions and answers

Summary of Contents for Konwin Home GDSFP-1500AS

  • Page 1 Electric Fireplace Stove with Heater OWNER’S MANUAL Model No. GDSFP-1500AS PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

  • Page 2: Important Instructions

    Thank you for choosing a Konwin Home Electric Fireplace. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.

  • Page 3: Specifications

    15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO NOT unplug by pulling on the cord. 16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use. 17.
  • Page 4 Tools Required for Assembly (not included): Phillips screwdriver ASSEMBLY INSTRUCTIONS Lay stove upside down on a padded surface with the underside accessible. Attach leg to stove by inserting the tab on the top of the leg into the corresponding slot on the bottom of the stove.

  • Page 5: Product Diagram

    PRODUCT DIAGRAM Handle Ember Bed Control Panel Heater / Blower Assembly Location of Controls 1. Thermostat control knob - Adjust to maintain room temperature 2. Heat Switch - Two switches for high heat setting 3. Heat switch – One switch for low heat setting 4.

  • Page 6: Automatic Cut-Off

    AUTOMATIC CUT-OFF A cut-off switch is fitted to the heating element to prevent damage due to overheating. If it cuts- off due to an obstruction in the airflow, the heater must be allowed to cool for 5 minutes and the obstruction must be removed before restarting.

  • Page 7: Maintenance

    MAINTENANCE 1. Replacing Light Bulbs CAUTION: Even though the glass is safety glass it may break if bumped, struck or dropped. Care must be taken when handling the glass. This electric stove uses clear 120V / 25W, G9 socket base light bulbs (candelabra base, B bulb). Access the 25W bulbs through the rear access panel (see illustration below).

  • Page 8: Troubleshooting

    TROUBLE SHOOTING If the heater will not operate, please check the following before seeking repair of service: 1. Check if the power cord is plugged into an electrical outlet, if not, plug in. 2. Check if electricity to the outlet is working. STORAGE Store the heater in a cool, dry location when not in use.

Table of Contents