Software Update; A.1 Troubleshooting - Strong SRT 810 User Manual

Use pq to highlight a major city near you and press ok to select. You can enter a city manually.
Press the GrEEn button Change City to open a keyboard. Use pq t u to enter. If you need to use
special symbols, press P+/P-. To save the name, select at the end Save and press ok.

7.6 Software update

This receiver is equipped with a different methods to update the software.
This can be used to add new functions, improve functions and to keep the receiver up-to-date.
7.6.1 S/W upgrade by oTA or oTI
The Over-The-Air (OTA) or Over-The-Internet (OTI) software upgrade function is checking
automatically if new a version is available. If a new version is available then a message box appears
on screen. Select ok to start download and update immediately. Select  if you like to update
another time. An OTA or OTI update might not be available in your region. Please visit our website
www.strong.tv or contact your local service hotline for more information about this option.
7.6.2 upgrade by uSb
This feature allows you to update the receiver software via the USB port. When a new software is
available for your receiver, it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory
stick etc.) and connect the device to the USB port of the receiver. First a message box will appear that
a USB device is found. After a short time a message will appear on screen again with the message
New software available. Select ok to start download and update immediately. When ready, the unit
will reboot automatically.
noTE:
WArnInG:
Warning
A.1 TroubLEShooTInG
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem
LED indicator is not lit
If, after a software update, the receiver should behave in an unexpected
way, please perform a factory reset as well. See chapter 7.1.4..
After an update the receiver restarts automatically. During the upgrade
process NEVER disconnect the receiver from the mains or switch off the
power! Doing so might damage your receiver and will void warranty!
Old channel list and favourites will be overwritten.
Possible cause
The mains lead is unplugged
What to do
Check the mains plug
21