Table of Contents INTELLIGENT SPEED DOME INSTALLATION ..........1 Installation Environments ........................1 Check installation space and installation location intension ............1 Please keep all package material well for future use ............... 1 SETUP BEFORE INSTALLATION ..............2 Check Accessories ..........................2 Open Device ............................
Page 4
Welcome Thank you for purchasing our speed dome! Please read the following safeguards and warnings carefully before you install or use the product!
Important Safeguards and Warnings Safety Measures 1. Qualified Engineer Needed The installation engineer or maintenance engineer shall have corresponding CCTV system installation certificate or maintenance qualification certificate. The installation engineer or maintenance engineer shall have qualification certificate for work at height.
Page 6
electromagnetic field. Violent vibration or crash is not allowed during transportation and application. Before you connect the cable, install or uninstall, or begin the daily maintenance work, please turn off the power and unplug the power cable. Please make sure the produce is secure firmly on the wall or the ceiling. 10.
Page 7
This series product shall be away from the strong electromagnetism radiant, please keep it away from wireless power, TV transmitter, transformer and etc. 7. Daily Maintenance Please use the soft cloth to clean dust on the shell, or you can use soft cloth with cleaning liquid to clean the shell and then use soft cloth to make it dry.
1 INTELLIGENT SPEED DOME INSTALLATION 1.1 Installation Environments Basic Requirement All installation and operation here should conform to your local electrical safety codes. Before installation, please open the package and check all the components are included. Please make sure the speed dome installation environment and installation mode can meet your requirement.
2 SETUP BEFORE INSTALLATION 2.1 Check Accessories Before the installation, please check the accessories one by one according to the packing list. Please make sure all the components listed are included. (Please check the container list for details.) 2.2 Open Device Remove the package and then take out the device.
2.4 SD Card Slot and Rest Button SD card slot and button is shown in Figure 2-3. Please make sure the SD card is in the non read-write state when removing it. Otherwise, it may result in data loss and SD card damage. The button is used for default setting. Long press Reset button for more than 5 seconds, the system configuration information will be recovered to default setting.
3 CAMERA INSTALLATION 2-inch network speed dome mainly adopts ceiling mount mode, which can be installed on the ceiling or wall. 3.1 Component Installation The installation of pedestal seal ring is shown in Figure 3-1. Figure 3-1 The ceiling mount speed dome is shown in Figure 3-2. Figure 3-2...
3.2 Installation Steps 3.2.1 Installation Environments The ceiling mount speed dome can be installed in the hard construction ceiling in the indoor environment. Before the installation, please make sure: The ceiling is thick enough to install the expansion bolt. ...
4 APPENDIX Ⅰ LIGHTENING PROTECTION AND SURGE PROTECTION This series speed dome adopts TVS lighting protection technology. It can effectively prevent damages from various pulse signals below 2000W, such as sudden lighting and surge. While maintaining your local electrical safety code, you still need to take necessary precaution measures when installing the speed dome in the outdoor environment.
Page 14
APPENDIX Ⅱ12V DC WIRE GAUGE AND TRANSMISSION DISTANCE RELATIONSHIP SHEET The recommended max transmission distance is under the following environments: The wire diameter is fixed and the DC 12V power voltage loss rate is below 10%. For the device of DC power supplying, the max allowed voltage loss rate is 10%.
Page 16
Note This manual is for reference only. Slight difference may be found in the user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks are the properties of their respective owners.
Need help?
Do you have a question about the sd22204t-gn and is the answer not in the manual?
Questions and answers