Page 1
This will allow the recycling of raw materials and help protect the environment. FOR HELP OR ADVISE ON THIS PRODUCT PLEASE CONTACT YOUR DISTRIBUTOR, 03936 OR SIP DIRECTLY ON: TEL: 01509500400 EMAIL: sales@sip-group.com or technical@sip-group.com Please read and fully understand the instructions in www.sip-group.com...
And the following harmonised standard(s) BS EN 61558-2-6:1998 BS EN 61558-1:1998+A1:1998+A11:2003 BS EN 55014-1:2006 BS EN 55014-2:1997+A1:2001 BS EN 61000-3-2:2006 BS EN 61000-3-3:1995+A1:2001+A2:2005 EN 61000-6-1:2007 EN 61000-6-3:2007 Signed: …………………………………... Mr P. Ippaso - Director - SIP (Industrial Products) Ltd Date: 26/04/2011.
Page 3
Turn on the power at the mains. The battery power level will illuminate to show that the Rescue Pac is being charged. Note: The internal battery of the Rescue Pac 1600 should be charged be- fore initial operation for 48 hours.
Switch the ignition of the vehicle on as you would normally start the vehicle. HAVE YOUR RESCUE PAC REPAIRED BY A QUALIFIED PERSON: The Rescue Pac 1600 is in Once the vehicle has started, remove the clamp immediately from the vehi- accordance with the relevant safety requirements.
Page 5
Wear safety goggles during use. Use of an accessory or attachment not recommended or sold by SIP, may result in a risk of damage to the unit, or injury to personnel. Do not recharge the Rescue Pac with a damaged plug or cord. Replace the broken part immediately.
Connecting to the power supply: void your warranty The mains charger for the Rescue Pac 1600 is designed to work with a standard 230v ~ 13 amp supply. Before using the mains charger, inspect it to ensure that it is not Caution: The warnings and cautions mentioned in this user manual can not cover all possible conditions and situations that may occur.
Need help?
Do you have a question about the rescue pac 1600 and is the answer not in the manual?
Questions and answers
SIP Rescue Roadside Starter Battery Pack Jump Start Charger 1600 Vehicle Booster . will it start a 2.7 6 cylinder engine