Craftsman 10134 Operator's Manual page 6

STEP (5):
AA(6)
DD(6)
EE(6)
Note: Shelf (D) from step (4) must be installed in bottom middle
location to allow door to latch and lock. Top and bottom shelves
should have slots facing toward back of unit. Install top shelf first.
• Insert shelf (D) from bottom of unit. Note: Flanges shoud face
toward bottom of cabinet.
• Place each shelf in desired mounting location in back of unit,
and rotate into place as shown.
• Attach each shelf using (2) bolts (AA), (2) washers (DD), and
(2) nuts (EE) in each shelf through square mounting holes as
shown.
AA
DD
EE
Flanges toward
bottom
bottom
Notch
in front
Note: Shelves may be organized in several different
configurations. Below is the recommended initial shelf spacing.
Top and bottom shelf spacing may be adjusted as necessary.
[
/
/
/
From step (4)
Lower middle
mounting position
Bottom
I
q
J
Top
f
STEP (6):
AA(4)
BB(8)
DD(4)
\_ .J
EE(12)
• Insert bottom (G) into bottom end of cabinet and attach as
follows.
• Use (4) bolts (AA), (4) washers (DD) and (4) nuts (EE)in
square holes.
• Use (4) screws (BB), and (4) nuts (EE) in round holes on
sides.
• Use (4) screws (BB), and (4) nuts (EE) in round holes on back.
,!
AA
DD
In square
Use
holes
with AA .... /
¢
÷
BB
_EE
i!
It
,J