Table of Contents
Advertisement
Connecting power
These steps connect power to the BSGX4e unit by using the AC adaptor included with
the unit.
1. Connect the labeled 12V DC on the back panel of the BSGX4e. See
page 18
2. Connect the AC plug to the appropriate AC receptacle (power cord or outlet).
3. Ensure that the LED labeled STATUS on the front panel is lit green. If not,
ensure that the power connections are secure and that the outlet has power.
Connecting LAN devices
Repeat these steps for each LAN port on the BSGX4e that you want to connect to a
LAN device (such as a PC or a VoIP phone).
1. Connect one of the connectors of an RJ45 to RJ45 ethernet cable to one of the
four LAN connectors (labeled 4, 3, 2, 1) on the back panel of the BSGX4e. See
Figure 4
The cables can be straight or crossover. The LAN switch automatically determines
if pairs need to be crossed over.
2. Connect the RJ45 connector on the other end of the cable to the LAN port of
the device to which you want to connect.
You can connect any LAN device to any LAN port, including workstations, VoIP
telephones, and patch panels.
3. Ensure that the corresponding LAN LED on the front panel is lit green. If it is
not, ensure that the cable connectors are locked and secure in their ports.
Connecting the WAN
These steps connect the BSGX4e to the WAN.
1. Connect one of the connectors of an RJ45 to RJ45 Ethernet cable to the WAN
connector on the back panel of the BSGX4e. See
The cable can be straight or crossover. The WAN port automatically determines if
pairs need to be crossed over.
2. Connect the RJ45 connector on the other end of the cable to the service
provider demarcation point. This point is usually an access router that
connects the network to the WAN.
3. Ensure that the WAN LED on the front panel is lit green. If it is not, ensure that
the cable connectors are locked and secure in their ports.
19
NN47928-303
.
on
.
page 18
Figure 4
on
BSGX4e Business Gateway Installation Guide
Figure 4
on
.
page 18
Release 01.01
Advertisement
Table of Contents
