32.4.10.1 Step by Step Trim System Setup
On-ground Setup
After setting up and testing the GSA 28 based autopilot and yaw damper systems, the pilot can configure
the trim system.
1. Go to the AP pages in configuration mode and enable the Trim Motor Control for all servos that
are connected to auxiliary trim motors.
190-01115-01 G3X/G3X Touch Install Manual - GDU 45X/46X Config and Post Install Checkout
Rev. AA
Page 32-99
Need help?
Do you have a question about the G3X and is the answer not in the manual?
Questions and answers