Installation - Nolan N-Com B3 User Instructions And Safety

3.

INSTALLATION

You can download the installation video from
Fig. 1
Fig. 3
Fig. 4
Fig. 6
www.n-com.it N-Com / Download section.
Remove the "N-Com" protection plate

located on the helmet shell (Fig. 1)
open the helmet chin guard (flip up
helmets).
Remove the right and left cheek pads from

the helmet
provided in the user manual of the helmet).
Remove the Noise Reducers from the two

cheek pads, and tear off the pre-cut plastic
(if equipped).
Remove the back of the comfort padding

by pulling on the neck roll until it separates
from the shell (Fig. 4).
 Temporarily put the padding on the outside
of the helmet (Fig. 5).
 Remove the N-Com cover from the helmet
border gasket. Push from the inside of the
helmet to facilitate the removal (Fig. 6).
Fig. 2
(see specific instructions
Fig. 5
B3
and
7