Dual Digital Vfos; Automatic Power Off (Apo) - Kenwood TS-50S Instruction Manual

DUAL DIGITAL VFOs
A
VI'O
and
VI'O
B function independently, so that
different frequencies can be set in each VFO. Use
these buttons to operate the VFOs:
A/B button
Press to toggle between
VI'O
A and B.
2
3
Assume that you are presently on A
VI'O
and
have selected 7.000 MHz.
A"'"
nnnnn
I. t.1 U U. U , ..
7g20~Q'"
4 "
a
10 LSB
Press the A/B button.
VI'O
B is selected, and another frequency (for
example the factory default, 14.000 MHz) is
displayed.
" " " "-OW
ILlnnnn
1 I. U U t.1. t.1
<H,
5 7 9 20 40
~";m
4 6 II 10 USB
4 Press the A/B button to toggle back to the A VI'O
on 7.000 MHz.
A=B button
Press this button to transfer the frequency and
modulation mode of the active VFO to the inactive
VFO.
1 Assume that you are presently on A VI'O and
have selected 7.000 MHz .
• "'0
nnnnn
I. t.,
U
u.
U ,",
3 5 7 9
2040
" .
2 •
~
" , 0 LSB
2 Press the A/B button.
3
VI'O
B is selected, and another frequency (for
example the factory default, 14.000 MHz) is
displayed.
' - I.
nnnn
1.t.IUU.U, ..
5 7 " 2040 Go. •
• s a w
USB
4 Press the A=B button.
6 OTHER USEFUL FEATURES
5 Press the A/B button again.
You will return to A
VI'O
and find that the
frequency and modulation mode have been
replaced by the
VI'O
B values.
AUTOMATIC POWER OFF (APO)
If the buttons or controls listed in the table are not
operated for approximately a 180 minute fixed interval,
the transceiver will automatically switch off. One
minute before this time is reached, the APO indicator
will appear on the display, and the transceiver will
"beep" continuously for one minute. These beeps do
not stop until after you operate one of the buttons or
controls in the table below. If none are operated within
the one minute period, the transceiver simply switches
off. The setting may be changed so that Automatic
Power Off will not activate. Refer to Menu Set-up
(Menu B, No. 64) on page 47. The default is OFF.
r
I
Buttons 'AT TUNE, AlP/An, NB, F.LOCK,
: DOWN, UP, MHz, A/B, SPLIT, A=B,
. SSB/CW, FM/ AM, RIT, SCAN, CLR,
M.IN, M
> v,
M/V
- - -
Controls
TUNING, RIT, IF, SHIFT
Microphone
I
pn, UP, DOWN, PF1, PF2, PF3, PF4
J
Note:
1 With APO
on,
the timer stops counting during scan, AT tuning,
or in the Menu Set-up mode.
2 The 180 minute interval is not adjustable.
3 Pressing
a
button
or
turning
a
control restarts the 180 minute
counter Immediately, even during the firJal one mmute warning
period before power switches off.
42