Samsung 6 Series User Manual page 9

6
7
8
9
10
Auto Tuning:
Selecting how you
watch your TV
Auto Tuning
(2):
(Depending on the
country) Selecting a
search options
Auto Tuning
(3)
Memorising
channels.
Clock: Setting the
Clock Mode
Time Zone
(Depending on the
country): Setting the
your Time Zone
Setup Complete
If You Want to Rerun Setup ...
Menu - System - Setup
Select an appropriate option of your home system using your remote
and then select Next.
• Yes, I need to.: Memorise all of the available channels using RF
cable. If you select this option, go to Step 7.
• No, I don't need to.: Do not need Auto Tuning when connecting a
TV to set-top-box. If you select this option, go to Step 9.
Select the channel source to memorise. If you select Digital & Analogue,
Digital or Analogue, The Auto Tuning starts.
The TV will start memorising channels. Channel memorisation can take
up to 45 minutes, depending on your cable system.
For more information, refer to Auto Tuning (Channel Menu -
Memorising Channels) in the e-Manual.
~
Select Stop at any time to Interrupt the memorisation progress.
• Auto: Set the current time automatically.
• Manual: Allows you to manually set the current date and time.
This step is only available when the clock mode is set to Auto.
• Auto: Set the time zone automatically.
• Manual: Set the time zone manually.
~
If you selected Manual, you can select whether to turn DST (Daylight
Savings Time) On or Off. (Depending on the country)
Select Close to finish.
~
The completed settings are displayed.
You should do Setup again at home although you did in shop.
If You Want to Turn the Store Demo Mode On or Off.
To set or unset Store Demo mode outside of Setup, press and release the Controller when the power is
on. The Function menu screen appears. Push the Controller to the left (to MENU
((II]))
and hold for more
than 5 seconds. The Store Demo mode is set. To cancel Store Demo, bring up the Function menu using
the Controller, push the Controller to the right (to Source (-EJ)) and hold for more than 5 seconds.
If You Want to Reset This Feature ...
Select System - Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0". If
you want to change the PIN number, use the Change PIN function. You should do Setup (Menu - System)
again at home although you did in shop.
~ If you forget the PIN code, press the remote control buttons in the following sequence in Standby
mode, which resets the PIN to "0-0-0-0": MUTE - 8 - 2 - 4 - POWER (on).
English-9