boori Forever Assembly Instruction page 3

Assembly as a Cot(two people required):
Insert 2 X wooden dowels (B) into the middle hole of the fixed side panel.
Stage 1
:
Attach base to both end panels using 4 X110mm connecting bolts (K).
(Keep all bolts loose at this stage).
Stage 2:
The upper holes on the end panels are for the higher base position.
Note
:
Pull both end panels outward to allow space for assembly of dropside panel.
Stage 3
:
Remove the drop side (see cot assembly instructions).
Remove the 4 drop side glide pins.
Reposition the base to the higher position (top hole of end panels).
Remove the fixed side.
Tilt the Junior Bed on one side and remove the end panel adjustment legs( X
2). Flip the unit on its other side and remove the remaining end panel
adjustment legs.
Block all remaining holes with the 8
X
40mm connecting bolts (E) and 8
capping nuts (L) provided.
Safely store the left over bits and pieces in the original box for later use
when converting to Sofa and Double Bed.
Converting to the Junior Bed
:
Tighten all connecting bolts (do not over tighten).
Screw 4 X glide pins (A) into both end panels (as shown) using Phillips
head screwdriver (not supplied). Then tighten firmly (do not over tighten).
Connect both end panels to the fixed side panel with 8 X 110mm connecting
bolts (K).(Keep all bolts loose at this stage).
Place one end of dropside panel into the runner first (lining up glide pins with
holes on the runner). Then the other by pulling both ends inward.
Screw in both locking screws as shown.
Block remaining holes on both end panels using 4 X 54mm connecting
bolts (G) and 4 X capping nuts (L).
To lower the drop side panel: Pull the drop side panel up (from the
center of top rail) and hold in that position while push bottom rail inward (at
the center) with your leg. Then allow the drop side panel to slide down.
To raise the drop side panel: pull the drop side panel up (from the center
of top rail) until it clicks into locking position.