Do you have a question about the 45-0503 and is the answer not in the manual?
Questions and answers
Summary of Contents for SPLIT SECOND 45-0503
Page 1
IMPORTANT: The engine is shipped without oil. Add oil before starting the engine. Place Model Number Label in Center of this Box. French and Spanish language manuals Before operating your Split Second are available to download at Log Splitter, read and understand www.splitsecondlogsplitter.com all instructions inside this manual.
Safety and Operational Labels This page contains copies of all the Safety and Informational labels that are found on your log splitter. Replace any damaged or missing labels immediately. Order by the part number shown with each label. Refer to the back cover for ordering information.
Safety Rules Remember, any power equipment can cause injury if operated improperly of if the user does not understand how to operate the equipment. Exercise caution at all times when using power equipment. WARNINg General Safety y Read and understand the instructions in the owner's manual before operating the log splitter. y Never allow anyone who has not read and understood these instructions to operate the log splitter.
Operating Instructions Never allow more than one person at a time to use the log splitter. This log splitter is designed for use by only one person. The same person should both load and operate the log splitter. Use by more than one person at a time creates a risk of injury.
Never allow more than one person at a time to use the log splitter. This log splitter is designed for use by only one person. The same person should both load and operate the log splitter. Use by more than one person at a time creates a risk of injury. WARNINg OPERATOR Using the Log Splitter...
Page 8
Never attempt to split logs across the grain; damage to the splitter or injury to you could occur. (See Figure 9.) Always split logs end to end, WARNINg with the grain. 7. If a log is forked, split one leg at a time. Do not try to split down the middle of the fork.
Maintenance Instructions PROCeDuRe BeFORe eACH AFTeR 20 eVeRY 50 eVeRY 100 HOuRS HOuRS HOuRS ü Check for loose fasteners ü Check tire pressure ü Check engine oil level ü ü Change engine oil ü Check and clean air cleaner ü Grease Rack ü...
Grease the Wheel Bearings – (See Figure 10.) COTTER PIN 1. Use a jack to lift the rear of the log splitter. Place supports SEAL under the frame for stability. WASHER 2. Remove the hub cap and pull the cotter pin from one axle. ROLLER BEARING 3.
Service and Adjustments INNER OUTER Adjusting the Belt Tension – (See Figure 11 and 12.) NOTe: The belt tension is correct when moderate pressure, applied to the belts midway between the two pulleys, results in 1/2" of deflection of the belts. 1.
Replacing the Wheel Bearings – (See Figure 14.) COTTER PIN 1. Use a jack to lift the rear of the log splitter. Place supports SEAL under the frame for stability. WASHER 2. Remove the hub cap and pull the cotter pin from one axle. ROLLER BEARING 3.
Troubleshooting PROBLeM POSSIBLe CAuSe(S) CORReCTIVe ACTION Engine fails to 1. Stop switch at OFF position 1. Turn switch to ON. start 2. Fuel shut-off valve closed. 2. Open fuel shut-off valve. 3. Fuel tank empty, or stale fuel. 3. Fill tank with clean, fresh fuel. 3.
Specifications Wheels/Tires Highway rated at 45 MPH Hitch Type 2" Ball Hitch Towbar Retractable Max Log Diameter 30 in Max Log Length 24 in Cycle Time 3 seconds Rack Width 2.25 in. Pinion Shaft Diameter 1.5 in. Ram Carriage 4 Heavy Duty Sealed Bearings Flywheel Diameter 18.25 in.
We truly appreciate your purchase of the Split Second Log Splitter. After you have split a few thousand pieces of firewood, please take a picture and send us an e-mail. We would enjoy seeing you with your pile of firewood.
Need help?
Do you have a question about the 45-0503 and is the answer not in the manual?
Questions and answers