1. Manuals
  2. Brands
  3. Partner Manuals
  4. Trimmer
  5. T330+
  6. Instruction manual

Partner T330+ Instruction Manual

Partner tech trimmer user manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

T330+
INSTRUCTION MANUAL
IMPORTANT INFORMATION
: Please read these instructions carefully and make
GB
sure you understand them before using this unit. Retain these instructions for future
reference.
MANUEL D'INSTRUCTIONS
RENSEIGNEMENTS IMPORTANTS:
Avant d'utiliser cet appareil, veuillez lire
FR
atentivement les instructions et assurez- -vous de les avoir comprises. Conservez
les instructions pour référence ultérieure.
BETRIEBSANWEISUNG
WICHTIGE INFORMATION:
Lesen Sie diese Hinweise zur Handhabung des
DE
Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie
alle Anweisungen verstanden haben und gut aufbewahren.
MANUAL DE INSTRUCCIONES
INFORMACIÓN IMPORTANTE:
ES
Lea atentamente las instrucciones y
asegúrese de entenderlas antes de utilizar esta aparato. Conserve las instruc-
ciones para la referencia en el futuro.
545058758
1/3/06

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T330+ and is the answer not in the manual?

Questions and answers

Related Manuals for Partner T330+

Summary of Contents for Partner T330+

  • Page 1 T330+ INSTRUCTION MANUAL IMPORTANT INFORMATION : Please read these instructions carefully and make sure you understand them before using this unit. Retain these instructions for future reference. MANUEL D’INSTRUCTIONS RENSEIGNEMENTS IMPORTANTS: Avant d’utiliser cet appareil, veuillez lire atentivement les instructions et assurez- -vous de les avoir comprises. Conservez les instructions pour référence ultérieure.
  • Page 2 14. Starter handle 3. ON/OFF switch 15. Fuel cap 4. Shoulder strap clamp 16. Primer bulb 5. Shoulder strap 17. Choke lever 6. Trimmer head 7. Line limiter blade 18. Muffler 19. Wrench 8. Shield 20. Hex wrench 9. Shaft 21.
  • Page 3 Keep people and animals 15 meters away. WARNING! Blade/trimmer line can throw objects violently. You and others can be blinded or injured. Always wear eye protection and leg protection. The operator of the machine must insure that no one comes within a 15 meter radius while working.
  • Page 4 S Never start engine with clutch shroud re- moved. The clutch can fly off and cause se- rious injury. S Be sure blade or trimmer head stops turning when engine idles. S Make carburetor adjustments with the low- er end supported to prevent blade or trim- mer line from contacting any object.
  • Page 5 Check carton contents against the following list: S Powerhead S Lower attachment S Blade and blade shield S Trimmer head and plastic shield S Nut (screwed onto plastic shield) S Handlebar S Bracket cover S Bracket cover screws (2) S Hex wrench...
  • Page 6 Secondary Hole Locking/Release Button in Primary Hole For optional attachments, see the AS- SEMBLY section of the applicable attach- ment instruction manual. ATTACHING THE HANDLEBAR DANGER: To avoid serious injury, the barrier portion of the handlebar must be installed as shown to provide a barrier between operator and the spinning blade.
  • Page 7 If your unit has a plastic cover over the threads on the threaded shaft, remove the covering to expose the threads. Before instal- ling the trimmer head, make sure the dust cup and retaining washer are positioned on the gearbox as shown below.
  • Page 8 Remove the trimmer head and plastic shield before attaching the metal shield and installing the weed blade. To remove the trimmer head, align hole in the dust cup with the hole in the side of the gearbox by rotating the dust cup.

  • Page 9: Starting Cold Engine

    OPERATION WARNING: Be sure to read the fuel information in the safety rules before you be- gin. If you do not understand the safety rules, do not attempt to fuel your unit. Contact an authorized service dealer. FUELING ENGINE WARNING: Remove fuel cap slowly when refueling.

  • Page 10: Starting Warm/Flooded Engine

    WARNING: Always stop unit and dis- connect spark plug before removing or instal- ling attachments. REMOVING TRIMMER ATTACH- MENT (OR OTHER OPTIONAL AT- TACHMENTS) CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
  • Page 11 S Operate the engine at full throttle. S Hold the trimmer head parallel to and above the grassy area. S Tap the bottom of the trimmer head lightly on the ground one time. Approximately 2 inches (5 cm) of line will be advanced with each tap.
  • Page 12 SCALPING - - The scalping technique removes unwanted vegetation down to the ground. Hold the bottom of the trimmer head about 3 in. (8 cm) above the ground and at an angle. Allow the tip of the line to strike the ground around trees, posts, monuments, etc.
  • Page 13 S Do not raise the engine above your waist as the blade can come dangerously close to your body. S Do not swing unit with such force that you are in danger of losing your balance. Bring the engine to cutting speed before enter- ing the material to be cut.
  • Page 14 S Always wear gloves when servicing or cleaning the tines. The tines become very sharp from use. S Do not run unit at high speed unless cultivating. HEDGE TRIMMER SAFETY DANGER: RISK OF CUT; KEEP HANDS AWAY FROM BLADE - - Blade moves momentarily after the trigger is re- leased.
  • Page 15 WARNING: Keep the pruner away from power lines or electrical wires. S Only use for pruning limbs or branches up to 4 inches in diameter. S Do not operate the unit faster than the speed needed to prune. Do not run the unit at high speed when not pruning.

  • Page 16: Clean Air Filter

    3. Wash the filter in soap and water. 4. Allow filter to dry. 5. Replace parts. SERVICE AND ADJUSTMENTS REPLACING THE LINE 1. Press the tabs on the side of the trimmer head and remove cover and spool. Cover Tap Button 2. Remove any remaining line.
  • Page 17 S Engine will not idle when the throttle is re- leased. S The trimmer head moves/spins at idle speed. Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object.
  • Page 18 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE Engine will not 1. ON/OFF switch in OFF start. position. 2. Engine flooded. 3.
  • Page 19 Racing, m/s YEAR OF CONSTRUCTION: 2006 MANUFACTURER’S ADDRESS: Electrolux Outdoor Products Italy Via Como 72 Valmadrera, Lecco ITALY I- -23868 Michael S. Bounds, Director Product Safety and Standards Blade Trimmer 7000 7000 10000 10000 7400 7400 3000 3000 #530055892 Opt.

Table of Contents

Save PDF