Borkey 396 euroline Instructions Of Use

Different possiblities of fixing the keys in the reversible vices
Side 1 Fixing of the keys at the base. For keys with a cutting depth of up to .5mm.
Standard cross keys up to a length of 120 mm.
Side 2 Fixing the keys at the base. For keys with a cutting depth less than 3.6 mm.
Cross keys with ring.
Side 3 Fixing of the keys at the base. For keys with a cutting depth less than 2.0 mm.
Side 4 Fixing of the keys in the profile (top side or bottom side of the keys).
Working instructions
Make sure, that both vices (for the pattern and the key blank) always indicate the
same position (side number).
For changing the position (side number) loosen knurled-nut (15) (pict.3) first and lift
the complete vice in order to turn to the required position (side number).
Keep vices always clean.
After turning of the vices push vices downwards and re-tighten knurled nut.
12
Semi automatic key cutting machine
Börkey 396 euroline
for cutting cylinder-,car- and cross keys up to 100 mm length
Main characteristics
• Copying every cutting angle without changing the cutter
• abraison parts are interchangeable
• maintenance-low cutting spindle fitted in a ball-bearing
• feeler fine adjustment
• when operating the carrige the cutter will start- and stop
running automatically
Technical Data
Input:
Voltage:
Frequency:
Weight:
Dimensions:
Sound level:
Protection fuse:
Standard tool kit equipment
1. 2 check up keys 9954-204-008
2. 1 O.E. spanner SW13/10 9000-204-002
3. 1 O.E. spanner SW22/19 9000-204-001
4. 2 flat bars with cut-out section 9994-W10-007
7. 1 allen key SW5 9000-022-005
8. 1 allen key SW4 9000-022-004
9. 1 allen key SW3 9000-022-003
10. 1 allen key SW2,5 9000-022-002
11. 1 allen key SW2 9000-022-001
12. 1 brush 9000-021-001
134 w
230v
50 cycles
29 kgs.
35 x 33 x 25 cms.
77 dB (A)
6 A
order no.
Pict. 1
1.
3.
2.
7.
8.
9.
10.
11.
12.
1
4.