Resolving Problems; Lcd Display On The Selection Panel; Fault Messages - ETNA nova freshbrew fp Instructions For Use Manual

Instruction for use Nova freshbrew FP
5

RESOLVING PROBLEMS

5.1

LCD display on the selection panel

If faults occur in the machine, the LCD display on the selection panel
will display a fault message.

5.1.1 Fault messages

Despite taking all precautionary measures, faults may occur in the
machine. In this case, a fault message is displayed. The table below
shows a number of faults that could occur and their causes and
remedies.
Fault message
Fill container x
Empty waste bucket
Rinse brewing group
Cleaning the brewing group
Empty drip tray
Replace filter roll
Exact change
Switch fault
Drink switched off
Replace lime scale filter
Boiler is heating up
No water
© ETNA Coffee Technologies b.v.
Cause
Container x is empty
The waste bucket is full
The drip tray is full
The filter roll has run out
Not enough change in money
changer
Switch is defective
Selected drink not available
Filter has exceeded its service
life
Boiler temperature is too low
Water level too low
C O F F E E T E C H N O L O G I E S
Remedy
Fill the container and reset the
fault message, see Filling con-
tainers
Empty waste bucket and clean
it, see Emptying waste bucket
Rinse the brewing group, see
Cleaning the brewing group
automatically
Cleaning the brewing group
manually, see Cleaning the
brewing group
Empty drip tray, see Cleaning
drip tray
Install a new filter roll, see
Installing filter roll
Pay with exact change
Contact your supplier
Contact your supplier
Replace the filter
Wait until the boiler has heated
up
Check the machine's water sup-
ply
31