Firmware Upgrading - Philips DVDR3300H Service Manual

EN 6 3. 3139 785 31480
3.

Firmware Upgrading

All new fi rmware will be published via
symptom/cure information at AYS website:
www.atyourservice.ce.philips.com
A. Preparation to upgrade fi rmware:
1. Unzip the zip-archive fi le
2. Start the CD Burning software and create a new CD project
(data disc) with the following settings:
File system
Format
Recording mode
Note: Long fi le name is necessary for the preparation of the
upgrade disc
3. Place the content of the zip-archive into the root directory of
the new CD project.
4. Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the fi rmware upgrade:
1. Hold the Record + Next buttons down and Power up
the set to go into "Forced Download". The tray door opens
automatically and the display shows:
DOWNLOAD ->..........PUT DISC
2. Insert the prepared Upgrade CDROM and close the tray.
3. The set will display:
READING -> DOWNLOAD ->..........
The whole process takes less than 10 minutes
Note: Do not press any buttons or interrupt the mains
supply during the upgrading process, otherwise the
set may become defective.
4. When the upgrade is completed the tray opens automatically
and the set will display:
REMOVE
5. Remove the Upgrade CDROM and close the tray. The
display shows:
DONE
6. The set switches automatically into Standby mode. Power off
the set to complete the download process.
Firmware Upgrading
: Joliet
: MODE 2: CDROM XA
: SINGLE SESSION (TRACK-
AT-ONCE), FINALIZED CD
C. How to read out the fi rmware version to confi rm
set has been upgraded.
1. Power up the set
2. Press <System menu> button on the Remote control and
select {Feature} option
3. Press <Right> to select {Access Control option}
4. Press <1> <5> <9> <6> buttons in sequence
5. The TV connected to the set will display:
AB 1.18.1.9 DB F05_4/53117
BE 43.2.14 SV 11203 DV 1234567890
BASE 52_221_20050730 dev sxc 3300h rad_int
SpectraCORE 3300v1.13