Paradyne FrameSaver 9720 User Manual page 161

Table 7-9.
9700-A2-GB20-20
PVC Connection Status Screen (2 of 2)
Field Display
DLCI DLCI (16–1007)
VPI,VCI
(0–15 VPI,
31–255 VCI)
EDLCI 0 to 62
IP
PM
Status
Active
Inactive
Disabled
Invalid
December 2002
7. Operation and Maintenance
What It Indicates
Identifies the source/destination of the
specified virtual circuit. Management PVCs
built on the ATM link display the VPI/VCI
value in parentheses instead of a DLCI
number.
For multiplexed DLCIs, a number from 0 to
62 identifies an individual link embedded
within a DLCI.
For IP Enabled DLCIs, IP is displayed. For
DLCIs not IP enabled that are the primary
destination of a payload managed PVC,
PM is displayed.
Identifies whether the physical interfaces,
LMIs, and DLCIs are all enabled and active
for this PVC connection.
The PVC is currently active. Both
Source and Destination Statuses must
be Active for the circuit to be active.
The PVC is inactive because:
– Alarm conditions and network and
SLV communication status indicate
that data cannot be successfully
transmitted.
– The unit has disabled the interface or
frame relay link due to internal
operating conventions.
The PVC cannot be activated as a result
of how the unit was configured. The
PVC may be disabled at one or both
ends of:
– The physical interface, or
– The frame relay link.
Some portion of the PVC connection is
not fully configured.
7-25