Advertisement
Do you have a question about the mystyle 16 and is the answer not in the manual?
No puedo calibrar las puntadas, se me recibe y corta el hilo
To calibrate the stitches and address thread cutting on a Janome Mystyle 16 sewing machine, follow these steps:1. Check the Needle: - Ensure the needle is the correct size for the thread and fabric. - Replace the needle if it is bent, blunt, or has a sharp eye.2. Inspect the Needle Plate: - Check for nicks or burrs at the needle plate hole. Replace or polish off burrs completely if found.3. Adjust Thread Tension: - Loosen the upper thread tension if it is too tight.4. Verify Threading: - Rethread the machine, ensuring it is done correctly.5. Inspect the Bobbin Area: - Check and correct the bobbin threading. - Clean lint from the bobbin holder and hook race.6. Remove Darning Plate: - Ensure the darning plate is not in place, as it may cause issues with thread cutting.By systematically addressing these potential issues, you can calibrate the stitches and resolve the thread-cutting problem.
This answer is automatically generated
Need help?
Do you have a question about the mystyle 16 and is the answer not in the manual?
Questions and answers
No puedo calibrar las puntadas, se me recibe y corta el hilo
To calibrate the stitches and address thread cutting on a Janome Mystyle 16 sewing machine, follow these steps:
1. Check the Needle:
- Ensure the needle is the correct size for the thread and fabric.
- Replace the needle if it is bent, blunt, or has a sharp eye.
2. Inspect the Needle Plate:
- Check for nicks or burrs at the needle plate hole. Replace or polish off burrs completely if found.
3. Adjust Thread Tension:
- Loosen the upper thread tension if it is too tight.
4. Verify Threading:
- Rethread the machine, ensuring it is done correctly.
5. Inspect the Bobbin Area:
- Check and correct the bobbin threading.
- Clean lint from the bobbin holder and hook race.
6. Remove Darning Plate:
- Ensure the darning plate is not in place, as it may cause issues with thread cutting.
By systematically addressing these potential issues, you can calibrate the stitches and resolve the thread-cutting problem.
This answer is automatically generated