Ingenico iwl250 Short Instruction Manual

Short instruction manual
iWL220/250
Keyboard
Function keys
The menu key F opens the
menu choice.
Stop key is used to stop the
current process or to go back
to the last Step.
To switch off the terminal press the keys
only if the terminal is not on the base. To switch it on, press the key OK

Card reading

Chip cards should be in-
serted as illustrated above
with the chip contacts
facing up. The card has to
remain until the end of the
process.
Copyright © 2013 Ingenico
F1 F2 F3
and
Magnetic stripe cards are
to be swiped as illustrated
above with the magstripe
down at the left side of the
card. Swipe the card not
too slow / not too fast with
a constant speed for best
reading accuracy.
20130529 KI_iWL_DIV2248EN.doc
F4
F1 and F4 are used to confirm
the current choice of the menu.
The arrow-keys F2 and F3 allow
to step up or down in the menu
to point to the required item.
The OK-key used to confirm the
current entry or menue choice.
The Clear-key is used to clear
the last entry.
The second function in idle-
mode ist he paper feed.
simultaniously for about two seconds. This works
or place it on the powered base.
Contactless cards are to held
above the display in a distance
below 1.5 inch. It is recom-
mended to arrive from the
bottom of the display to
watch the confirmation of the
four LED's.
nur iWL250
1/4