Help Menu - AudioControl DM-608 Installation Manual

Chapter 8: The Display
Tools Menu
The Tools Menu offers a few handy features, as one can never have
too many tools. Keep them sharp, clean, and bright, and store away
from children. Sand and varnish any wooden handles.
1. Set EQ flat – This is a quick way of returning the EQ curves to the
flat state.
2. Output Delay type – This allows you to select the output delay
units from length units in inches and metric, or time units in ms. In
terms of sound waves, 1 ms is approximately the time it takes for
sound to travel 1 foot, unless you are playing faster than usual.
3. Reset hardware to factory settings – Allows you to..well..reset the
hardware to the factory settings. You might try this if you are not
sure of the current settings, and want to start again with a clean
new start, fresh as a morning in early spring.
4. Set PIN – This allows you to change the secret security PIN number
from its initial factory setting of 1234, to a value all of your own.
Record the number on a piece of paper, memorize and eat it.
5. Upate device firmware – This allows you to search for and load
a new firmware file from a location on your computer. New
firmware files (with extension "bin") may become available on our
website www.audiocontrol.com. See page 20 for more details of
the firmware update procedure. Note that you should save your
current settings (if you like them) before updating the firmware.

Help Menu

1. Help – This brings up a copy of this manual as a PDF for your
enjoyment, after your dog shredded the paper manual and buried
it in the garden.
2. Videos – Watch adorable kittens tumble and lark about with yarn
and lasers on our website www.audiocontrol.com
3. About – Gives details of the currently loaded software application
for those curious thrill-seekers.
24
Installation Manual