DeWalt dcr002 Original Instructions Manual page 10

3. Activate the Bluetooth
mobile phone. Once the adapter is found (will appear as: D
Adapter DCR002) confirm pairing on your device. Once pairing is
successful the rapid red/blue flashing of the LED will cease and the
indicator will flash blue once every 5 seconds. If paired successfully,
your audio device should now be able to connect with the adapter.
Consult with your device's owners manual for details on pairing and
connecting.
LED indicator
Flashes red and blue rapidly
Flashes blue once every 2
seconds
Flashes blue once every 5
seconds
Flashes red once every 20
seconds
Flashes red and blue alternately
Solid red light
CoNNeCtiNG aNd MouNtiNG the adapteR to a WoRkSite Radio (FiG. 2, 3)
The Bluetooth
®
most non-D WALT work site radios and other audio devices with a
e
standard 3.5mm audio in jack.
The Bluetooth
®
or other speaker by mounting the adapter storage clip (e) to the radio.
Being mindful of the adapter's cord length in relation to your radio's audio
jack, apply the adhesive strips (f) provided on the back of the storage clip
and to a flat surface on your radio, refer to figure 3. Slide the adapter into
the storage clip and connect the 3.5 mm audio plug (d). Remove adapter
from clip for charging if necessary.
search function of your audio device or
®
adapteR StatuS iNdiCatoR
adapter is compatible with all D
adapter can be mounted and stored on a work site radio
Status
Adapter is in pairing mode.
Adapter is in standby mode and
not connected.
Adapter is paired with a device.
Adapter's battery is low and
needs to be charged.
Adapter is charging while
connected to an audio device
Adapter is charging
WALT work site radios,
e
English
WALT
e
31