Handling Of Firmware Page - Panasonic KX-TDA0484 Programming Manual

3.3.2

Handling of Firmware Page

1.
Click 2.2 Handling of Firmware Page in the main menu.
For details about the parameters on this screen, refer to the descriptions below.
2.
Click Main Operation Mode for Operation to set the desired page as the active page on startup.
Note
Do not click Empty, as it is an option provided for engineer use only.
At any time during the session, you can:
• Click MENU to return to the main menu (see "3.1 Main Menu for the Installer").
• Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "3.4.2 Log Out").
3.
Click the option for the page in the "NEW" status for Select Page to specify it as the target page
of the operation.
4.
Click OK.
You will see a confirmation screen.
5.
Click OK.
You will see a result screen.
6.
Click OK.
You will be taken back to the Handling of Firmware Page screen.
Parameter Descriptions
Parameter & Description
Program Version
Indicates the current version of the two firmware data in the
VoIP Gateway Card: page 0 and page 1.
3.3 Data Management
Default Value Range
Display only
Programming Guide 61