Advertisement
LC2H
5. Output setting mode
This sets the operation mode.
+
Press the SET key while pressing
HOLD-A
the MODE key.
SHOT-B
1) Pressing the SET key four times while
holding down the MODE key takes you to
the output setting mode.
2) The display reads "HoLd-A" (initial
setting) after entering the output setting
mode.
3) Pressing the setting key causes the
display to change as follows:
HOLD-B (Output maintain/over count I)
SHOT-A (One shot/over count)
SHOT-B (One shot/recount I)
HOLD-A (Output maintain/hold count)
4) Pressing the front panel reset key sets
the display content and returns you to
regular operation mode.
Note: You will not be returned to regular operation
mode if you do not press the front panel reset
key.
Changing the preset value
1. It is possible to change the preset
value even during counting. However,
be aware of the following points.
1) If the preset value is changed to less
than the count value with counting set to
the addition direction, counting will
continue until it reaches full scale, returns
to zero, and then reaches the new preset
value. If the preset value is changed to a
value above the count value, counting will
continue until the count value reaches the
new preset value.
Compliance with the CE marking
• EMC Directive (89/336/EEC)
The LC2H Preset Counter conforms to
the EMC Directive as a simple counter.
Applicable standards: EN61000-6-4,
EN61000-6-2
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
2) Lock mode
+
HOLD-B
Press the SET key while pressing
SHOT-A
the MODE key.
When the lock is set, you cannot enter modes other than
backlight setting mode.
3) Backlight setting mode
+
Press the SET key while pressing
the MODE key.
4) Input setting mode
+
Press the SET key while pressing
the MODE key.
5) Output setting mode
+
Press the SET key while pressing
the MODE key.
Mode changes as follows by pressing the SET key while holding down the MODE key.
Lock mode
Output setting mode
Please be aware that after doing a front
panel reset key and returning to regular
operation mode, the preset values, count
value and output will be as shown in this
table.
2) Suppose that the counter is preset to
count down. Whether a preset count
down value is smaller or larger than the
count value, the counter counts down to
"0 (zero)".
2. If the preset value is changed to "0",
the counter will not complete count-
up. It starts counting up when the
counting value comes to "0 (zero)"
again.
Un-Lock
Lock
Lit red
Flashes green
Lit green
Flashes red
Front panel reset key
Regular operation mode
Addition
Subtraction
HOLD-A
HOLD-B
SHOT-B
SHOT-A
Backlight setting mode
Input setting mode
Lock
mode
Backlight
setting
mode
Input
setting
mode
Output
setting
mode
Note: "×" sign: No change
1) Addition (up-count) input when
counting is set to the addition direction,
counting will continue until full scale is
reached, return to zero, and then
complete count-up.
2) Subtraction (down-count) input when
counting is set to the subtraction direction,
counting will continue until full scale
"–9999999" is reached, and then the
display will change to "
Preset
Output
Count value
value
change
×
×
×
×
×
×
Addition: "0"
×
Subtraction:
ON➝OFF
"Preset value"
Addition: "0"
×
Subtraction:
ON➝OFF
"Preset value"
".
Advertisement
